0% found this document useful (0 votes)
466 views4 pages

Experiment Number 4 (A) Binary Frequency Shift Keying Modulator (B-FSK)

The document describes an experiment to implement and study binary frequency shift keying (BFSK) modulation and demodulation. BFSK represents binary digits as two distinct frequencies, called the mark and space frequencies. The experiment involves building a BFSK modulator circuit using common components like op-amps, transistors, and diodes. Key steps are to observe the modulated output waveform on an oscilloscope and measure the mark and space frequencies and modulation index. A BFSK demodulator circuit is also described using a phase-locked loop integrated circuit to recover the original baseband signal from the modulated carrier.

Uploaded by

Shyam Ji Rana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
466 views4 pages

Experiment Number 4 (A) Binary Frequency Shift Keying Modulator (B-FSK)

The document describes an experiment to implement and study binary frequency shift keying (BFSK) modulation and demodulation. BFSK represents binary digits as two distinct frequencies, called the mark and space frequencies. The experiment involves building a BFSK modulator circuit using common components like op-amps, transistors, and diodes. Key steps are to observe the modulated output waveform on an oscilloscope and measure the mark and space frequencies and modulation index. A BFSK demodulator circuit is also described using a phase-locked loop integrated circuit to recover the original baseband signal from the modulated carrier.

Uploaded by

Shyam Ji Rana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

EXPERIMENT NUMBER 4(a)

Binary Frequency Shift Keying Modulator (B-FSK)


AIM: To study and implement Binary FSK modulation and demodulation schemes and to observe the
waveform.

EQUIPMENT REQUIRED:

Equipment Range Quantity

CRO (0-20) MHz 1


Function Generator (0-1) MHz 1
Power Supply (0-30) V 1
+12V 1

COMPONENTS REQUIRED:

Component Value Quantity


IC XR2206 1
Timer IC 555 1
PLL IC 565 1
Transistor BC107 1
Op-amp IC741 1
Diode
Resistors 1K 3
10K 3
4.7K 2
100K 1
Capacitors 1nF 1
22uF 1
.01uF 2
1uF 1

THEORY:

Frequency-shift keying (FSK) is a frequency modulation scheme in which digital information is transmitted
through discrete frequency changes of a carrier wave. The two binary states logic 0 (low) and 1 (high) are
represented by an analog waveform. Logic 0 is represented by a wave at a specific frequency, and logic 1 is
represented by a wave at a different frequency. One frequency is designated as the “mark” frequency and the
other as the “space” frequency. The mark and space frequency are corresponding to binary one and zero,
respectively. FSK finds a wide range of application in low-speed digital data transmission systems. Their appeal
is mainly due to the hardware advantages that result principally from the use of non-coherent demodulation
process and the relative ease of signal generation.

PROCEDURE:

1. Connections are made as per the circuit diagram.


2. Set the AF input (say 1Vpp, 150Hz) using function generator.
3. Observe the output waveform on the CRO.
4. Plot the observed waveform on the CRO.
5. Identify the mark and space frequency.
6. Find the mark frequency (Fm) and space frequency (Fs).
7. Calculate the modulation index MI=| Fm - Fs |/(F0/2) where F0 is the fundamental frequency of the input
signal.
CIRCUIT DIAGRAM:

WAVEFORM:
EXPERIMENT NUMBER 4(b)

Binary Frequency Shift Keying Demodulator


EQUIPMENT REQUIRED:

Equipment Range Quantity

CRO (0-20) MHz 1


Function Generator (0-1) MHz 1
Power Supply (0-30) V 1
+12V 1

COMPONENTS REQUIRED:

Component Value Quantity

IC 565 (PLL-IC) 565 1

IC-741 (OP-AMP) Ic 741 1

Potentiometer 10K 1

Resistors 1K 2

10K 3

33K 1
Capacitors 0.02uF 3
0.01uF 2
0.2uF 1

CIRCUIT DIAGRAM:
THEORY:

The demodulation methods for FSK can be divided into two major categories: FM detector demodulator and
filter-type demodulator. The FM detector demodulator treats the FSK signal as a simple FM signal with binary
modulation.

PROCEDURE:

1. Connections are made as per the circuit diagram.


2. Give the FSK modulated signal as input to pin no. 2.
3. Observe the output waveform on the CRO.

You might also like