0% found this document useful (0 votes)
22 views2 pages

KVR1333D3S9/8G: Memory Module Specifi Cations

Download as pdf or txt
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 2

Memory Module Specifications

KVR1333D3S9/8G
8GB 2Rx8 1G x 64-Bit PC3-10600
CL9 204-Pin SODIMM

Important Information: The module defined in this data sheet is one of several configurations available under
this part number. While all configurations are compatible, the DRAM combination and/or the module height may
vary from what is described here.

DESCRIPTION SPECIFICATIONS
This document describes ValueRAM's 1G x 64-bit (8GB) CL(IDD) 9 cycles
DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory Row Cycle Time (tRCmin) 49.5ns (min.)
module, based on sixteen 512M x 8-bit FBGA components. The Refresh to Active/Refresh 260ns (min.)
SPD is programmed to JEDEC standard latency DDR3-1333 Command Time (tRFCmin)
timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold Row Active Time (tRASmin) 36ns (min.)
contact fingers. The electrical and mechanical specifications Power (Operating) 1.200W*
are as follows:
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
FEATURES Storage Temperature -55o C to +100o C

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply *Power will vary depending on the SDRAM used.
• VDDQ = 1.5V (1.425V ~ 1.575V)

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with


starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ


pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,


3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB: Height 1.18” (30mm), double sided component


Continued >>

Document No. VALUERAM1032-001.A00 11/16/11 Page 1


MODULE DIMENSIONS:

(units = millimeters)

Document No. VALUERAM1032-001.A00 Page 2

You might also like