RELATED TITLES

73 views 0 1

1st Assignment (Design 1)

Uploaded by FaizMuhamadZain 
design 1 assignment uthm Full description

   
Save Embed Share Print Chap Lecture+4+-+One+Dimensional+Elements
lab sheet.pdf Sheet_1_
4_REFRIGERATION

 1st Assig
BDA 31203 & BDA 30803  –  1
Session 2015/2016 Sem

Student Name: _______________________

__________________________________
_______________
____

Matric Card No.: ________________

________________

Section:  ________

Figure below shows a shaft mounted in bearings at A and D and having pulleys at B and C . Th
forces shown acting on the pulley surfaces represent the belt tensions. Change the xx term in t
 belt tension with your last two digits from your matric card number. The shaft
shaft is to be made
made o
AISI 1035 CD steel. Using a conservative failure theory with a design factor of 2, determine t
minimum shaft diameter to avoid yielding.

150 mm D.
12xx N

200 N
120 N

16xx N

150 mm
200 mm D.

200 mm

200 mm

Fill in the blank with the correct answers.

1) Load determination;
determination;  A y = ____________ N ;  D y =____________ N

 A z  = ____________ N ;  D z  = ____________ N (4 ma

( Put
 Put a negative (  the direction of the axis)
 –  ) sign if it against the

2) Bending moment load;  M  = Nm ;  M  =_________ Nm

 RELATED TITLES
73 views 0 1

1st Assignment (Design 1)

Uploaded by FaizMuhamadZain 
design 1 assignment uthm Full description

   
Save Embed Share Print Chap Lecture+4+-+One+Dimensional+Elements
lab sheet.pdf Sheet_1_
4_REFRIGERATION

BDA 31203 & BDA 30803  –  1st Assig

Session 2015/2016 Sem

3) Torque at location B and C; T  B = __________ Nm ; T C  = ___________ N

(2 ma

4) Stresses at location B and C in term of ‘d ’;

At location B;   
 x_B = ___________ Pa ;   
 xy_B  = ___________ Pa

At location C;   
 x_C  = ___________ Pa ;   
 xy_C   = ___________ Pa

(4 mark

5) Maximum shear stress at location B and C in term of ‘d ’;

At location B;   max_B  = ___________ Pa

At location C;   max_C  = ___________ Pa

(2 mark)

6) Critical location? _________ (1 mark)

7) Minimum shaft diameter required? d min = ____________ mm (1 mark)

KEY IN ALL YOUR ANSWERS IN THE BOX AT THE EXCEL FILE GIVEN AND SA
THE EXCEL FILE IN 2003 VERSION FORMAT WITH THE NAME OF YOUR MAT
CARD NUMBER (e.g.  –  AD000001.xls). THEN SENT THE SOFTCOPY OF THE FILE
YOUR LECTURER EMAIL ADDRESS ACCORDING TO YOUR CLASS SECTION

[email protected] –  for BDA 31203 Section 1 & 2

[email protected]  –  for BDA 31203 Section 3 & 4