Scribd
Upload
471 views

Simple Icom CI-V Interface

Icom appears to delight in charging outrageous prices for all transceiver accessories, so many Hams improvise instead.

Uploaded by

Mike
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
471 views

Simple Icom CI-V Interface

Icom appears to delight in charging outrageous prices for all transceiver accessories, so many Hams improvise instead.

Uploaded by

Mike
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Simple Icom CI-V Interface Sida 1 av 2

G3VGR Icom CI-V Interface

Icom appears to delight in charging


outrageous prices for all transceiver
accessories, so many Hams improvise instead.
A few circuits have been published for CI-V
interfaces, most of which use the MAX232 IC.
Here is a very simple CI-V interface, originally
described by OK2WY. I've made small
changes to the modem control signals
connections. Although the circuit doesn't
conform exactly to the RS-232 specification, it
does work well and has the advantage of being
easily constructed inside a 9 pin D-type shell.
Please note that the resistor value 4K7 means
4700 ohms. The transistor types are not
critical, I just happen to have plenty of
2N2222As.

I've used this interface on various PC's and


also Dell Latitude Notebooks with both an
IC735 and IC706MkIIG. No problems have
been experienced even at 19200 baud with the
IC706. It has also worked successfully when
using a USB/Serial adapter from a
notebook. If a PTT function is required from
the COM port, pin 7 (RTS) can be used to
provide this facility.

The circuit is powered by DTR (pin4). I


experienced some problems with YPLog using
this power source. If YPLog is configured to
use PTT from either the Parallel port or a
different serial port from the one used by the
CI-V Interface, the program drops the DTR
signal, resulting in no power to the interface.
This is easily resolved by powering the circuit
from RTS (pin 7) instead of DTR (pin4).

I have also used this interface to program my


Yaesu FT50R. Only a change of connector to a
4 pole minijack plug was required. Probably
the interface can be used with other HTs,
although I have not tried it.

Disclaimer: Although I have tested and used the above circuit on my own IC735 and IC706mkIIG with no
problems, I do not make any representation or guarantee that this circuit will function, nor do I accept any

http://www.qsl.net/g3vgr/civ.html 2007-09-24
Simple Icom CI-V Interface Sida 2 av 2

responsibility whatsoever for any damage or malfunction arising from the use of this circuit.

Here are some links to software for use with CI-V controlled Icom rigs:
CI-V Test by DF4OR - Freeware program to test CI-V bus
CI-V Commander by AA6YQ - Freeware program to control Icom rigs and monitor CI-V bus
RadioComm by KE7ZZ - Careware program to control and load memories of Icom rigs
IC706 Memory Manager by G4FEV - Freeware program to load IC706 memories
YPLOG by VE6YP - Shareware Icom Rig control and logging program

[Home]

http://www.qsl.net/g3vgr/civ.html 2007-09-24

You might also like