Scribd
Upload
28 views

An Investigation Into The Parametric Optimization of Al-2219 Using CNC Wire Edm by Using Taguchi Method

This document investigates using the Taguchi method to optimize the parameters for CNC wire electrical discharge machining (WEDM) of aluminum alloy 2219. It analyzes how pulse on time, pulse off time, and peak current affect material removal rate and surface roughness. Experiments were conducted using an L9 orthogonal array. Analysis of variance and Taguchi methods were used to determine the optimal levels for each parameter. Confirmation experiments validated the optimal results.

Uploaded by

afsinan k n
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
28 views

An Investigation Into The Parametric Optimization of Al-2219 Using CNC Wire Edm by Using Taguchi Method

This document investigates using the Taguchi method to optimize the parameters for CNC wire electrical discharge machining (WEDM) of aluminum alloy 2219. It analyzes how pulse on time, pulse off time, and peak current affect material removal rate and surface roughness. Experiments were conducted using an L9 orthogonal array. Analysis of variance and Taguchi methods were used to determine the optimal levels for each parameter. Confirmation experiments validated the optimal results.

Uploaded by

afsinan k n
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AN INVESTIGATION INTO THE PARAMETRIC OPTIMIZATION OF

Al-2219 USING CNC WIRE EDM BY USING TAGUCHI METHOD

ABSTRACT

Optimization is one of the techniques used in manufacturing sectors to arrive for the best

manufacturing conditions, and essential need for industries towards manufacturing of quality

products at low cost. This paper aims to investigate the optimal set of process parameter such

as pulse on time, pulse off time and peak current in wire electrical discharge machining

(WEDM) process to identify the variation in performance characteristic such as material

removal rate (MRR) and surface roughness (Ra) value on the work material for machining

Aluminium 2219 using brass electrode. Based on the experiment conducted on L9 orthogonal

array, analysis has been carried out using ANOVA and Taguchi method. Response table and

graphs were used to find the optimal levels of parameters in WEDM process. The confirmation

experiments were carried out to validate the optimal results.

AFSINAN K N

ASHMIL SHA MUHAMMED P

ASHIK K J

You might also like