Custom Casework Pages From 03-Arch
Custom Casework Pages From 03-Arch
Custom Casework Pages From 03-Arch
SECTION 06410
CUSTOM CASEWORK
PART 1: GENERAL
A. Furnish all labor, materials, equipment and incidentals required and install
kitchen cabinets and tops as shown on the drawings and specified here in.
B. Section 06200 - Finish Carpentry Related trim not specified in this section.
1.03 REFERENCES
C. Samples: Submit one (300 x 200 mm) size sample, illustrating cabinet finish
and material.
D. Samples: Submit one (250 x 150 mm) size sample, illustrating counter top
finish and material.
PART 2 PRODUCTS
C. MDF panel: Shall be made of 18mm for kitchen cabinets medium density
fiberboard (MDF) moisture resistant, density of 700 kg/m3, panel covered
with 120gms. Of plastic laminate per square meter on both sides.
2.02 DOORS
A. Doors
To be 18mm thick (MDF) for kitchen cabinets, veneered with plastic laminate.
A. Plastic Laminate: AWI, 0.9mm thick, color and surface texture as selected
.
2.04 CARCASE
A. Sides:
B. Decks:
C. Bottom:
D. Shelves:
E. Backing:
Shall be made of 3.0mm thick white coated medium density fiberboard (MDF)
panel.
2.05 PLINTH:
A. as shown on ID drawings.
2.06 SINK:
A. (Refer to ID cutsheets
A. Work top: Shall be 10.5mm thick porcelain slabs with backsplash, as shown
on drawings and stated on BOQ.
2.09 ACCESSORIES
B. Plastic Edge Trim: Extruded flat shaped; smooth finish; self locking serrated
tongue; of width to match component thickness; color as selected.
C. Wire Glass: Clear, polished both sides square mesh of woven stainless steel
wire of 18 mm) grid size; 6 mm) thick.
E. Bolts, Nuts, Washers, Lags, Pins, and Screws: Of size and type to suit
application; Stainless Steel finish in concealed locations and Galvanized
finish in exposed locations.
2.10 HARDWARE
A. Shelf Standards and Rests: Formed steel channels and rests, cut for fitted
rests spaced at (25mm) centers; chrome finish.
B. Shelf Brackets: Formed steel brackets, formed for attachment with lugs;
chrome finish.
C. Drawer and Door Pulls: Extruded aluminum pull, full width of drawer,
polished finish.
E. Cabinet Locks: Keyed cylinder, two keys per lock, steel with chrome.
H. Hinges: demountable and concealed type spring loaded, steel with chrome
finish, each door is hung by 2 nos. hinges.
PART 3 EXECUTION
3.01 EXAMINATION
B. Verify location and sizes of utility rough-in associated with work of this
section.
3.02 INSTALLATION
C. Use concealed joint fasteners to align and secure adjoining cabinet units and
counter tops.
E. Secure cabinet and counter bases to floor using appropriate angles and
anchorages.
3.03 ADJUSTING
3.04 CLEANING
END OF SECTION