Scribd
Upload
33 views5 pages

Assignment#5: PSA LAB Muhammad Nouman Saleem (2015-EE-36)

This document outlines 4 tasks for an assignment using Power System Analysis (PSA) Lab software: 1) Model a 12 bus system and add fields to buses and branches, 2) Perform load flow analysis and add voltage contouring, 3) Perform 3-phase short circuit analysis on a bus, 4) Export the Ybus to Matlab, calculate the Zbus, and display it. The tasks are accompanied by instructions to add screenshots after completing each implementation.

Uploaded by

Anonymous L1jskn1hoR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views5 pages

Assignment#5: PSA LAB Muhammad Nouman Saleem (2015-EE-36)

This document outlines 4 tasks for an assignment using Power System Analysis (PSA) Lab software: 1) Model a 12 bus system and add fields to buses and branches, 2) Perform load flow analysis and add voltage contouring, 3) Perform 3-phase short circuit analysis on a bus, 4) Export the Ybus to Matlab, calculate the Zbus, and display it. The tasks are accompanied by instructions to add screenshots after completing each implementation.

Uploaded by

Anonymous L1jskn1hoR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Assignment#5: PSA LAB

Muhammad Nouman Saleem (2015-EE-36)


Task #1:

Model 12 bus system, shown in above diagram, in PWS. Name and numbering of each bus must
be properly assigned, as shown. {-2} For each bus, add following fields on the one-line
Diagram. {-4} Bus Name. Bus voltage (pp.). Bus voltage angle.
For each branch, add following fields on the one-li
ne diagram
{-3}
MW and MVAR flow at both ends. MVA limit (Show at the center of the branch)
Pie charts to display %age loading.
Add snaps of the system after completing the implem
Enation.
Task #2:
Perform the load flow analysis of the system. [10] Use contouring function to show voltage
profile of the system. Add snaps of the system after applying contouring function. {-4}.

If voltage is either very low (less than 0.95 up) or high (above 1.05 up), correct this
Problem. Add snaps of system after all these modifications.
Task # 3.
Perform 3-φ short circuit analysis on any bus to generate Bus of the system. [5]
Add print screen image of Positive sequence Y
Bus generated by PWS. {-3}
Task # 4.
Export the Ybus in Matlab and find Zbus by inverting Bus . [5]
Add snaps of the Zbus displayed in Matlab command window. {-5}
Pop out command window from Mat lab window so that a
All the columns get displayed in one window.

Zbus =

You might also like