Scribd
Upload
317 views3 pages

Home Assignment 1 Applied Geometry

This engineering drawing homework assignment contains 5 problems: 1) finding centers and drawing inscribed/circumscribed circles for given shapes; 2) drawing arcs tangent to given lines with a 12mm radius; 3) drawing an arc with a 10mm radius tangent to a circle and line; 4) drawing all possible 15mm radius arcs tangent to two circles; and 5) drawing all possible 60mm radius arcs tangent to two other circles. It also contains an extra exercise to draw a rocker arm view and an ellipse defined by given major and minor diameters.

Uploaded by

AN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
317 views3 pages

Home Assignment 1 Applied Geometry

This engineering drawing homework assignment contains 5 problems: 1) finding centers and drawing inscribed/circumscribed circles for given shapes; 2) drawing arcs tangent to given lines with a 12mm radius; 3) drawing an arc with a 10mm radius tangent to a circle and line; 4) drawing all possible 15mm radius arcs tangent to two circles; and 5) drawing all possible 60mm radius arcs tangent to two other circles. It also contains an extra exercise to draw a rocker arm view and an ellipse defined by given major and minor diameters.

Uploaded by

AN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Home Assignment # 1

Engineering Drawing
Applied Geometry

Refer to the explanatory notes of Lecture 1 (lecture_1 cont.pdf) to draw the following:

1. Find the center of the following Shapes and draw the inscribing and circumscribing circles:

2. Draw an arc tangent of radius 12 mm to each of the lines shown:

3. Draw an arc of radius 10 mm, tangent to the circle and the straight line shown:

1
Home Assignment # 1
Engineering Drawing
Applied Geometry

4. Draw all possible arc(s) of radii 15 mm, tangent to the two circles shown:

5. Draw all possible arc(s) of radii 60 mm, tangent to the two circles shown:

2
Home Assignment # 1
Engineering Drawing
Applied Geometry
Extra Exercise

On a separate A4 paper, draw the following view of the Rocker arm:

Draw the ellipse represented by the following major and minor diameters:

You might also like