0% found this document useful (0 votes)
30 views

Controller Install Introduction: After Selecting

The document discusses controller installation and provides instructions for using the controller with and without a driver. It can be used with drivers for Windows XP, Windows 7 32-bit, Windows 7 64-bit, Windows CE, and Windows XP operating systems. For non-driver use, the calibration program must be run to configure settings like active time for right click functionality and double click area size. Key settings like force sensitivity and double click sensitivity can be adjusted and saved to the firmware as needed. Calibration is usually required after installing the non-driver program to ensure normal touch functionality.

Uploaded by

JulioJ.Roncal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
30 views

Controller Install Introduction: After Selecting

The document discusses controller installation and provides instructions for using the controller with and without a driver. It can be used with drivers for Windows XP, Windows 7 32-bit, Windows 7 64-bit, Windows CE, and Windows XP operating systems. For non-driver use, the calibration program must be run to configure settings like active time for right click functionality and double click area size. Key settings like force sensitivity and double click sensitivity can be adjusted and saved to the firmware as needed. Calibration is usually required after installing the non-driver program to ensure normal touch functionality.

Uploaded by

JulioJ.Roncal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Controller Install introduction

Controller support two working mode- With driver & without driver. The one with driver can be worked under OS
WinXP/Win7 32bits/Win7 64bitsWin CE/WinXPE. The one Without driver can be worked under OS Windows, Linux,
Android .
With driver and without driver switch: controller has been set as without-driver controller when it was produced , client
need to install the driver program from the Driver file . According to the corresponding operating system to install the suitable
driver.
If you need to use the no-driver type,please click Cali-PNP calibration program in PNP file(Please click the right mouse
underWin7,then to operate calibration program as administrator),and follow the below setting :

PNP:Choose this section, click “Save set” to set the controller to without driver. Note: only select this function ,the other
function setting can take effect .
Active Time : Default value is 0, if the client need Right-click function ,just select the time of the appearance of right-
click,click “Save set” is OK .
Double Click Setup:
Height:The Double-click area’ height of Mouse and Touch screen.
Width:The Double-click area ‘ width of Mouse and Touch screen.
This function main set the double-click area,It usually has been set the default values in the factory ,the client need not to
adjust.
Setp:Default is 12, if the Double-click is not sensitive ,you can increase the step length, range from 6 to 28.
Press:Touch force,the factory default is 10,normally need not to adjust. touch force is divided into 28 levels, you can set the
touch screen sensitive via changing numerical value. If the customer need better handle,please turn down the numerical
value,instead, turning up the numerical value to increase the local anti-jam capabilities. Then click “Save set”.
Save Set:Save the Settings in the firmware, and take effect immediately.
Draw Test:Customers can do click and draw lines testing in the drawing board
UnTouch:Touch has no date output after selecting .
Touch:Touch can normal output data after selecting.
Calibrate: Four point calibration ,calibration screen will pop up after clicking, follow the screen prompt to finish it. After
install no-driver program, usually need to calibrate the cursor to ensure normal touch .

You might also like