Scribd
Upload
241 views3 pages

Indigo Interview Questions

The document contains questions about aircraft systems and components including: gas path cleaning, hydraulic systems, starters, flight control computers, cargo doors, torque measurements, pumps, seals, pressures, fuels, and other aircraft technical topics. It seeks explanations and definitions related to maintenance, operations, and specifications.

Uploaded by

Rajesh M
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
241 views3 pages

Indigo Interview Questions

The document contains questions about aircraft systems and components including: gas path cleaning, hydraulic systems, starters, flight control computers, cargo doors, torque measurements, pumps, seals, pressures, fuels, and other aircraft technical topics. It seeks explanations and definitions related to maintenance, operations, and specifications.

Uploaded by

Rajesh M
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

• Purpose of gas path cleaning & which ports or line open during gas path cleaning?

• Why USI is conducted?


• Running torque, Breaking torque, Dry torque, Wet torque?

• SI unit of torque & Pressure.

• Basic of Hydraulic system.

• Basic about RAT.

• Flight Control computers & their location.

• Specific gravity & their units.

• How to open cargo door manually?

• What are the things to be checked while taking seals from store?

• What are the points to be kept in mind while taking torque wrench from store?

• What is Spool?

• How starter rotate the spool, while teeth of starter engaged in accessory gearbox?

• Mallet & Screwdriver (Question about their size).

• Numerical related to extension used in torque wrench.

• Handling bleed valve, Hp valve,& Over pressure valve(Question about locations & Their
use).

• How engine Thrust rating is changed?

• Snag rectification is confirmed from which manual?

• Torque of the bolt is mentioned in which chapter of AMM?

• Replacement of any component is referred from which manual?

• Engine mounts (Which bolt open first).

• IDG location & about their internal operation.

• Rating of emergency generator.


• What happen if the sense lines going to FADEC are blocked?

• What are the things that a yellow hand can operate?

• Fan cowl latch opening & closing sequence?

• T/R cowl latch opening & closing sequence?

• Advantage of Fly by Wire.

• Number of Flight control Computers.

• Unit of fuel in Aircraft.

• Electrical System rating.

• Where to find part number?

• Color code of oxygen system.

• Torque used in oxygen fittings.

• What all to check in part obtained from stores?

• What is 1/10th of thou?

• How to open cargo doors with yellow pump inoperative?

• How to check if self locking nut in the good condition?

• Precautions while putting seals.

• Time gap for measuring tire pressure.

• Fuelling precautions

• Micrometer, Vernier use.

• Definitions of British thermal unit (B.T.U.) .Calorie, Absolute pressure, Ambient


temperature /pressure, Cabin altitude, Differential pressure.

• Question about Hard hammer, soft hammer, ball peen hammer, cross peen hammer.

• Fuel leak- Slow seep, seep, Heavy seep, running leak.


• If there is positive & negative error in TPG then what is your action to measure correct
pressure?

• Question about Special tool used in removing O-ring.

• Hydraulic line tightening procedure.

• Cabin air-conditioning & pressurizing system components.

• Color coding of pipe lines

• Type of split pin locking

• Question about different ATA

• Difference between ATF & Gasoline

• Difference between Flexible hose & rigid tube.

• Question on definition & use of momentum.

You might also like