Scribd
Upload
46 views1 page

WWW - Manaresults.Co - In: Set No. 1

This document contains exam questions for a Design for Manufacture course. It has two parts: Part A contains 6 short answer questions about topics like DFM, DFA, DFMS, center design, blow holes in casting, forging operations, drawing vs. deep drawing, and injection molding applications. Part B contains 3 long answer or essay questions about designing for economical production, design rules for manufacturability, design for machining rules and problems, general casting design considerations, design guidelines for brazed joints, design considerations for drawability, and Keeler Goodman forging diagrams. It also contains questions about plastic component design guidelines and viscoelastic and creep behavior in plastics.

Uploaded by

Angadala ANKA RAJU
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views1 page

WWW - Manaresults.Co - In: Set No. 1

This document contains exam questions for a Design for Manufacture course. It has two parts: Part A contains 6 short answer questions about topics like DFM, DFA, DFMS, center design, blow holes in casting, forging operations, drawing vs. deep drawing, and injection molding applications. Part B contains 3 long answer or essay questions about designing for economical production, design rules for manufacturability, design for machining rules and problems, general casting design considerations, design guidelines for brazed joints, design considerations for drawability, and Keeler Goodman forging diagrams. It also contains questions about plastic component design guidelines and viscoelastic and creep behavior in plastics.

Uploaded by

Angadala ANKA RAJU
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Code No: RT41038 R13 Set No.

1
IV B.Tech I Semester Supplementary Examinations, February/March - 2018
DESIGN FOR MANUFACTURE
(Mechanical Engineering)
Time: 3 hours Max. Marks: 70
Question paper consists of Part-A and Part-B
Answer ALL sub questions from Part-A
Answer any THREE questions from Part-B
*****

PART–A (22 Marks)


1. a) Differentiate between DFM, DFA and DFMS. [4]
b) Explain on centre design with sketch. [4]
c) What is the effect of blow hole in design for casting? [4]
d) What is forging operation? [3]
e) What is the difference between drawing and deep drawing operation? [3]
f) Give the applications of injection molding process. [4]

PART–B (3x16 = 48 Marks)


2. a) Discuss briefly the basic principles of designing for economical production. [8]
b) List out and explain the general design rules for manufacturability. [8]

3. a) Discuss the applications of design for machining rules. [8]


b) What are the general problems we come across while designing for machining
operations? Explain how one can overcome those problems. [8]

4. a) Discuss the general design considerations for casting process. [8]


b) What is the importance of solidification in casting process? Explain. [8]

5. Briefly explain the design guidelines for brazed joints. [16]

6. a) Explain design considerations affecting drawability. [8]


b) Illustrate the Keeler Goodman forging line diagram. [8]

7. a) Explain the design guide lines for plastic components. [8]


b) Discuss about the visco elastic and creep behavior in plastics. [8]

1 of 1

WWW.MANARESULTS.CO.IN

You might also like