Scribd
Upload
97 views1 page

Split Casing Pump

The document outlines required maintenance procedures for pumps, including applying grease to grease nipples, nuts, and bolts to prevent corrosion, tightening gland packing and frame nuts as needed, adjusting cooling lines and cleaning drain lines, keeping vents closed when not operating, adhering to manual instructions, not overriding safety measures, running the pump for 20 minutes every 2 weeks, and not operating continuously at incoming voltages below 400V to avoid overheating and damaging the motor winding.

Uploaded by

Jayath Bogahawatte
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
97 views1 page

Split Casing Pump

The document outlines required maintenance procedures for pumps, including applying grease to grease nipples, nuts, and bolts to prevent corrosion, tightening gland packing and frame nuts as needed, adjusting cooling lines and cleaning drain lines, keeping vents closed when not operating, adhering to manual instructions, not overriding safety measures, running the pump for 20 minutes every 2 weeks, and not operating continuously at incoming voltages below 400V to avoid overheating and damaging the motor winding.

Uploaded by

Jayath Bogahawatte
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Required Maintenance Procedures

1. Applying grease to grease nipples


2. Applying grease to nuts and bolts
3. Tightening gland packing as necessary
4. Tighten the Frame nuts as necessary
5. Apply grease to the nuts and bolts to avoid corrosion.
6. Adjust the cooling line water supply as needed. Clean the drain lines of the cooling water
storing compartments.
7. Keep the vents closed when pump is not operating
8. Adhere to the Instructions on the pump manual.
9. Do not override any safety measures unless failures in safety measures.
10. Please turn on the pump for 20mins at least once every 2 weeks.
11. The incoming voltage is between 380V-390V. It must be 400V for continuous operation.
This will have an increase in current draw to the pump motor, which in the long run will
damage the motor winding. So do not operate the pump continuously. Please allow the
motor to cool at least once in two hours.

You might also like