Electrical, Instrumentation & Safety Check List
Electrical, Instrumentation & Safety Check List
2. INSTRUMENT CHECKLIST
Sr.
Content Yes No N/A
No.
1 Check Installation As Per P&Id And GA Drawing □ □ □
2 Check Identification Tags □ □ □
3 Check all report and certificates □ □ □
check pointer travels and verify instrument capability to
4 measure, operate and stroke in the direction and □ □ □
manner required by the process application
5 check Field calibrate instruments with standard test □ □ □
equipment
6 check Fully pressurize and energize the transmitting □ □ □
and control signal system
7 check open process connections at primary sensors □ □ □
and final regulators and control
check Installation and connected all system
8 components and verify their conformance with □ □ □
specifications and design criteria for function and range
using dummy transmitted signals as needed
9 check all transmission and control □ □ □
10 Check control circuits in accordance of QAP □ □ □
11 Check all electrical signals and alarm wiring for □ □ □
continuity, correct sources of power and polarity
12 Check all electrical signals and alarm wiring for □ □ □
continuity, correct sources of power and polarity
13 Check thermocouples for proper joining of wires, proper □ □ □
polarity and continuity of receiving instruments
14 check inline components such as control valves, □ □ □
positive displacement meters, turbine meters, etc.
15 Check bores of orifice plates □ □ □
16 Check designation and function of each isolator and □ □ □
fuse in electric systems
17 Check operation of automatic transfer systems, reset □ □ □
mechanisms, etc.
18 Loop checks all instrumentation from field to control □ □ □
room.
19 Witness all loop checks □ □ □
Check all control valves, on/off valves, lubricate as
20 required □ □ □
Sr.
Content Yes No N/A
No.
1 Are all work place clean and in good condition □ □ □
Is all Installation in good/stable condition and properly
2 □ □ □
adjusted
3 Are all walking or working surfaces free of □ □ □
tipping/slipping hazards
Are emergency phone numbers and procedures posted □ □ □
4
at or near telephones
5 Are machine and belt guards in place and in good □ □ □
condition
6 All moving parts are covered □ □ □
7 Is pedestal machinery securely anchored to the floor? □ □ □
8 Is all piping appropriately identified as to □ □ □
contents/direction of flow
9 Are hot pipes and surfaces guarded against contact □ □ □
and clearly marked “HOT”
10 Are exit signs posted and properly illuminated to clearly □ □ □
indicate exits
11 Are electric hand tools properly grounded/insulated □ □ □
12 Is the area free of extension cords □ □ □
13 Are circuit breaker panels free of combustible materials □ □ □
Is emergency equipment (alarm pull boxes, eyewashes,
14 showers, etc.) accessible and not blocked by □ □ □
equipment
15 Is all emergency equipment in good condition □ □ □
Is good housekeeping practiced in work area (Is it free
16 of debris, combustibles, obstructions? Are aisles □ □ □
maintained?
17 Are ladders is good and safe to use □ □ □
18 Are no smoking regulations clearly posted □ □ □
19 Are all extinguishers in place and properly mounted □ □ □