Scribd
Upload
22 views3 pages

Plug Arduino Board To Into Your Computers USB Port. Connect External LED in Series With A 1 Kohm Resistor To Pin 11 As Shown in Below Picture

The objective of this exercise is to upload a program to blink an external LED connected to GPIO pin 11 of an Arduino Mega board. The steps are to connect the LED in series with a 1k resistor to pin 11, open the Blink example sketch in the Arduino IDE, replace LED_BUILTIN with pin 11, select the board and port, and upload the program to make the LED blink on and off.

Uploaded by

lingesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
22 views3 pages

Plug Arduino Board To Into Your Computers USB Port. Connect External LED in Series With A 1 Kohm Resistor To Pin 11 As Shown in Below Picture

The objective of this exercise is to upload a program to blink an external LED connected to GPIO pin 11 of an Arduino Mega board. The steps are to connect the LED in series with a 1k resistor to pin 11, open the Blink example sketch in the Arduino IDE, replace LED_BUILTIN with pin 11, select the board and port, and upload the program to make the LED blink on and off.

Uploaded by

lingesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Session 2 Exercise 3:

Objective: Upload a program to blink external LED connected to one of the GPIO pins.

Steps:

 Plug Arduino board to into your computers USB port.



 Connect external LED in series with a 1 Kohm resistor to pin 11 as shown in below
picture.

 Open Arduino IDE. Go to example section to open blink program (sketch).


  Replace LED_BUILTIN with pin number 11.
 Select board and port from Tools menu.

  Click on upload button to flash program on Arduino mega board.


 Once program uploaded external LED will start blinking.
Code:

/*
Blink

Turns an LED on for one second, then off for one second, repeatedly.
*/

// the setup function runs once when you press reset or power the
board void setup() {
// initialize digital pin number 11 as an output.
pinMode(11, OUTPUT);
}

// the loop function runs over and over again forever


void loop() {
digitalWrite(11, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(11, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}

You might also like