Scribd
Upload
616 views2 pages

LDA Mcqs

1. Shunt generators have shunt windings in parallel with the armature winding, allowing them to require only one exciter. 2. AM encodes information in amplitude variations of the carrier wave, while FM encodes information in frequency variations. 3. If a large load is disconnected suddenly from a power plant, the turbine speed will increase and frequency will increase due to the decreased demand on the generator. 4. The document discusses various electrical engineering concepts and principles.

Uploaded by

Imran Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
616 views2 pages

LDA Mcqs

1. Shunt generators have shunt windings in parallel with the armature winding, allowing them to require only one exciter. 2. AM encodes information in amplitude variations of the carrier wave, while FM encodes information in frequency variations. 3. If a large load is disconnected suddenly from a power plant, the turbine speed will increase and frequency will increase due to the decreased demand on the generator. 4. The document discusses various electrical engineering concepts and principles.

Uploaded by

Imran Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

1. Shunt generator has shunt winding in parallel with armature winding.

The advantage is:


Only require one exciter, does not require exciter,
2. Difference between amplitude modulation (AM) and frequency modulation (FM)? Options ka nai
pata
3. If large load is disconnected suddenly from power plant, then:
turbine speed will increase and frequency increase
turbine speed will decrease and frequency decrease
4. The function having infinite value
open, close, dependant, indepandant
5. ) Eddy current of dc generator ? no options
6. Negaitve sequence current ? no options
7. In an induction motor when air gap is increased then magnetizing current increases while short
circuit current will
A. Decrease
2. Increase
3. Initially increase then stabilized
4. Initially decreased then stabilized
5. Remain unchanged
) partial derivate theorem
laplace, newton,
8. optical device measure refraction
drummeter, durameter, opto , declipmeter
9. . If sampling and time shifting are applied on a same signal, what should be the order of
operation?
A. sampling, shifting
B. shifting, sampling
C. can't apply both
10. . in 8086, while the instruction is read when first byte is stored at...
a) 0911A
b) code segment
c) registers
d)anywhere in memory
11. potential difference in static electric field?
a.independent of electric field
b.depends on electric field
c.p.d is zero
d.not remember
12. - Instrument for measuring ocular focus or refraction of eyes.
13. - The fact as to how closely the instrument reading follows the measured variables is called the
precision.
fidelity.
accuracy.
sensitivity
14. In a video channel there is modulation and ________
A.Laser
B.LED
15. Conversion stage from continues to discret is
1 ) sampling 2 ) quantization 3) decoding
16. In low head power plants,
Low volume & high presssure
Low volume & low pressure
High volume & low pressure
17. The impedance offered by the system to the flow of negative sequence current is called negative
sequence impedance?
18. Dynamic controller
A)PID B)harolap C)lyepor etc
19. rectifier with operatinal amplifier
a)passive b)active c)saturated D)non saturated
20. for open interval function we use
A)derivative B)not derivative C)dependent D)independent
21. The function having infinite value
open, close, dependant, indepandan

You might also like