Scribd
Upload
59 views1 page

Master Making Width Adjustment

This document provides instructions for adjusting the master making width on a copier or printer. 1) Run a test mode and check the value shown to determine if the paper size potentiometer is set correctly. The value should be 90 for A4 paper and 63 for B4 paper. 2) If the wrong value appears, turn the HEX SW7 switch until the correct value is displayed to calibrate the master making width adjustment. 3) Exiting the test mode returns the display to its initial condition.

Uploaded by

Rheana Domingo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views1 page

Master Making Width Adjustment

This document provides instructions for adjusting the master making width on a copier or printer. 1) Run a test mode and check the value shown to determine if the paper size potentiometer is set correctly. The value should be 90 for A4 paper and 63 for B4 paper. 2) If the wrong value appears, turn the HEX SW7 switch until the correct value is displayed to calibrate the master making width adjustment. 3) Exiting the test mode returns the display to its initial condition.

Uploaded by

Rheana Domingo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

MASTER MAKING WIDTH ADJUSTMENT <GR>

7. Master Making Width

4. Master Making Width Adjustment <GR>


1. To check whether the Paper size potentiomenter is adjusted to the correct setting, place A4 size or
B4 size paper on the Paper feed tray and slide the Paper guides against it.
2. Start up Test mode No.91 and press "START" key.
A certain number, which is the value given by the settings of the Paper size potentiometer and HEX
SW7 on the Image processing PCB, will appear aside "A/D DATA" in the Main LCD display for
GR3750 and GR2750 or in the print quantity display for GR2750 and GR1750.

"90" should be shown in the display with A4 size paper and "63" with B4 size one..

TEST MODE
Ver 1.23 SYSTEM 0
4.56 PANEL
( Test mode is started up )

TEST MODE
Ver 1.23 SYSTEM 91
4.56 PANEL
( Select Test mode No.91 )

TEST MODE
A/D DATA 67
91
The value given by the settings of the Paper
size potentiometer and HEX SW7.
"90" should be shown for A4 size paper.

3. If a different number is shown, turn the HEX SW7 until "90" appears in the display.

TEST MODE
A/D DATA 90
91
4. To exit from Test mode No.91, press "START" key.
The display on the Panel returns to the initial condition.

SELECT PRINT QUANTITY 0


LINE A4 BLACK

- Note -
• The actual width of master making will be 2mm narrower on Paper size Correct value
each side, compared to the original.
• Turning SW7 to a larger number will increase the Master A3 (297mm) 3C
making width.
B4 (257mm) 63
Turning it to a smaller number will decrease the width.
• One notch of SW7 will change the Master making width by A4 (210mm) 90
1mm.
B5 (181mm) Ad

A5 (148mm) Cd

APX (IV)-14 IV-1 < M.-M. Width Adjust > (GR3750/2750/2710/1750)

You might also like