Scribd
Upload
55 views3 pages

Topics To Be Covered SECTION A: D.C. Networks Laws and Theorems

The document is a lesson plan for an Electrical Engineering course covering topics in D.C. circuits, single phase A.C. circuits, three phase A.C. circuits, transformers, electrical machines, and measuring instruments over 40 lectures. Key topics include Ohm's law, Kirchhoff's laws, network analysis methods, phasor representation, active and reactive power, series and parallel A.C. circuits, resonance, transformers, D.C. machines, induction motors, synchronous machines, and various electrical measuring instruments and their operation. The lesson plan lists the topics to be covered in each lecture along with the textbooks being referred to.

Uploaded by

rajkumar r
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
55 views3 pages

Topics To Be Covered SECTION A: D.C. Networks Laws and Theorems

The document is a lesson plan for an Electrical Engineering course covering topics in D.C. circuits, single phase A.C. circuits, three phase A.C. circuits, transformers, electrical machines, and measuring instruments over 40 lectures. Key topics include Ohm's law, Kirchhoff's laws, network analysis methods, phasor representation, active and reactive power, series and parallel A.C. circuits, resonance, transformers, D.C. machines, induction motors, synchronous machines, and various electrical measuring instruments and their operation. The lesson plan lists the topics to be covered in each lecture along with the textbooks being referred to.

Uploaded by

rajkumar r
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

FORM NO. - GITM-FRM-73 (REV. NO.

00)

GURGAON INSTITUTE OF TECHNOLOGY & MANAGEMENT

Department : Electrical Engineering Session :Jan-June2018

Branch / Sem : ECE/EE / 2ND Subject Name & Code :Electrical technology ( EE-101-F)

LESSON PLAN TEACHER : Ms. Ritu Sharma

Books Referred:
1. Electrical Engineering Fundamentals by Deltoro.PHI
2. Network Analysis by Valkenburg
3. A Textbook Of Electrical Technology by B.L. Thereja (Vol.1 and Vol.2)

Lecture No. Topics to be Covered

1. SECTION A: D.C. Networks Laws and Theorems


Ohm’s Law
2. Series, parallel combination of resistances, Kirchhoff’s Laws

3. numerical

4. Loop methods of analysis

5. Numerical

6. Nodal analysis

7. numerical

8. Star to Delta & Delta to Star transformation

9. Numerical

10. Superposition theorem, numerical

11. Thevenin’s theorem, numerical

12. Norton’s theorem, numerical

13. numerical

14. Maximum power transfer theorem, Milman’s theorem

15. SECTION B: Single Phase A.C. Circuits


Sinusoidal signal, instantaneous and peak values ,RMS and average values, crest and
peak factor
16. Concept of phase, phasor representation-polar & rectangular exponential and
trigonometric forms
17. Behaviors of R,L and C components in A.C. circuits

18. Concept of active and reactive power, power factor

19. Series A.C. circuits

20. Parallel A.C. circuits

21. Series Resonance

22. Parallel Resonance

23. Q factor, cut-off frequencies and bandwidth.

24. Numerical

25. SECTION C: Three Phase A.C Circuits


Phase and line voltages and currents
26. Balanced star circuits

27. delta circuits, power equation

28. Measurement of power by two wattmeter method, Introduction to unbalanced circuits

29. Numerical

30. Transformers Construction, EMF equation

31. Ideal transformer, Phasor diagram on no load

32. Phasor diagram on full load ,equivalent circuit

33. losses, Open and short circuit test

34. regulation and efficiency, Application of DC machines


Moving Coil Type
35. SECTION D: Unit 5: Electrical Machine
Construction , Principle
36. Working, E.M.F. equation ,losses of D.C. machine

37. Comparison of construction and working of D.C. machine with Induction motor,
synchronous machine
38. Measuring Instruments
Construction, operation of moving iron type
39. moving coil type
Uses of moving iron type and moving coil type ,induction type ammeter, voltmeter
40. Watt meter, Energy meter

You might also like