Soil Behaviour in Earthquake Geotechnics

Soil Behaviour
in
Earthquake Geotechnics
KENJI ISHIHARA
Department of Civil Engineering
Science University of Tokyo
This publication was supported

by a generous donation from the
Daido Life Foundation
CLARENDON PRESS • OXFORD

1996
CONTENTS
1 CHARACTERISTICS OF DYNAMIC PROBLEMS 1

1.1 Range of strain 1
1.2 Differences between static and dynamic loading conditions 2
1.3 Dependency of deformation characteristics upon shear strains 3
2 CHARACTERISTIC CHANGES IN CYCLIC STRESS IN

TYPICAL DYNAMIC LOADING E N V I R O N M E N T S 6
2.1 Cyclic stresses during earthquakes 6
2.2 Traffic loading 10
2.3 Wave-induced loading 13
References 15
3 THE R E P R E S E N T A T I O N OF S T R E S S - S T R A I N
RELATIONS IN CYCLIC LOADING 16
3.1 The linear viscoelastic model 17
3.2 The nonlinear cycle-independent model 28
References 39
4 APPARATUS AND PROCEDURES FOR LABORATORY

TESTS 40
4.1 Triaxial test apparatus • 40
4.2 Simple shear test apparatus 43
4.3 Torsional shear test apparatus 44
4.4 Resonant column test 46
4.5 Wave propagation method in laboratory specimens 54
4.6 Cyclic loading tests with precise measurements of strains 56
References 58
5 IN SITU SURVEY BY WAVE PROPAGATION 60

5.1 Reflection survey 60
5.2 Refraction survey 62
5.3 Uphole and downhole methods 75
5.4 The crosshole method 66
5.5 Suspension sonde 68
5.6 Spectral analysis of surface waves (SASW) 73
References 85
6 LOW-AMPLITUDE SHEAR MODULI 85

6.1 Low-amplitude shear moduli from laboratory tests 85
viii CONTENTS
6.2 Time dependency of low-amplitude shear modulus 107
6.3 Low-amplitude shear moduli from in situ tests 112
6.4 Estimation of shear modulus from the in situ penetration test 119
6.5 Poisson's ratio for saturated soils 120
References 123
7 STRAIN D E P E N D E N C Y OF MODULUS AND DAMPING 127

7.1 Strain-dependent modulus and damping from laboratory tests 127
7.2 Evaluation of strain-dependent soil properties for in situ deposits 142
7.3 Factors affecting modulus reduction and damping characteristics 150
References 152
8 E F F E C T OF L O A D I N G S P E E D AND S T I F F N E S S
D E G R A D A T I O N OF COHESIVE SOILS 152
8.1 Classification of loading schemes 154
8.2 Deformation characteristics of soils under transient loading 162
8.3 Deformation characteristics of soils under cyclic loading 154
8.4 Evaluation of cyclic stiffness degradation 165
8.5 Threshold strains for cyclic degradation 172
8.6 Threshold strains and reference strain 177
References 177
9 STRENGTHS OF COHESIVE SOILS UNDER

TRANSIENT AND CYCLIC LOADING CONDITIONS 180
9.1 Load patterns in dynamic loading tests 180
9.2 Definition of dynamic strength of soil 180
9.3 Transient loading conditions 186
9.4 Combined static and cyclic loading 187
9.5 Irregular loading conditions 192
References 206
10 R E S I S T A N C E O F S A N D T O C Y C L I C L O A D I N G 208
10.1 Simulation of field stress conditions in laboratory tests 208
10.2 The mechanism of liquefaction 208
10.3 Definition of liquefaction or cyclic softening 218
10.4 Cyclic resistance of reconstituted clean sand 221
10.5 Cyclic resistance of in situ deposits of sands 225
10.6 Cyclic resistance of silty sands 227
10.7 Cyclic resistance of gravelly soils 228
10.8 Effects of ^o conditions on liquefaction resistance of sand 231
10.9 Cyclic resistance of sand under irregular seismic loading 233
10.10 Effects of confining stress and initial shear stress on liquefaction resistance 241
References 242
11 S A N D B E H A V I O U R U N D E R M O N O T O N I C L O A D I N G 247
11.1 Flow and non-flow in undrained sand samples 247
CONTENTS ix
11.2 Compression characteristics of sand and the method of sample
preparation 250
11.3 Steady state of sand 255
11.4 Quasi-steady state 257
11.5 Quasi-steady state of silty sands 262
11.6 Residual strength offines-containingsand 268
11.7 Estimate of residual strength 272
11.8 Effects of the fabric on residual strength 275
11.9 Effects of the deformation mode on residual strength 278
References 279
12 EVALUATION OF LIQUEFACTION RESISTANCE BY

IN SITU SOUNDINGS 282
12.1 Correlation based on field performances 282
12.2 Correlation based on laboratory tests 287
12.3 The effects of fines on cyclic strength 290
12.4 Correlation for gravelly soils 293
References 299
13 ANALYSIS OF LIQUEFACTION 301

References 306
14 SETTLEMENT IN SAND DEPOSITS FOLLOWING

LIQUEFACTION 308
14.1 Basic concepts and procedures 308
14.2 Evaluation of settlement 312
References " 315
15 FLOW AND NON-FLOW CONDITIONS AND RESIDUAL

STRENGTH 316
15.1 Flow conditions in SPT and CPT 316
15.2 Correlation of residual strength and penetration resistance 325
References 330
16 ONSET CONDITION FOR LIQUEFACTION AND

CONSEQUENT FLOW 331
16.1 Interpretation of laboratory tests to assess in situ strength 331
16.2 Onset conditions for liquefaction and consequent flow 333
References 344
APPENDIX: METHODS OF SAMPLE PREPARATION 338

A.I Moist placement method (wet tamping) 338
A.2 Dry deposition method 339
x CONTENTS
A.3 Water sedimentation method 340

References 340
INDEX 341

Soil Behaviour in Earthquake Geotechnics

Uploaded by

Copyright:

Available Formats

Soil Behaviour in Earthquake Geotechnics

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Soil Behaviour in Earthquake Geotechnics

Uploaded by

Copyright:

Available Formats

Soil Behaviour

This publication was supported

CLARENDON PRESS • OXFORD

1 CHARACTERISTICS OF DYNAMIC PROBLEMS 1

2 CHARACTERISTIC CHANGES IN CYCLIC STRESS IN

4 APPARATUS AND PROCEDURES FOR LABORATORY

5 IN SITU SURVEY BY WAVE PROPAGATION 60

6 LOW-AMPLITUDE SHEAR MODULI 85

7 STRAIN D E P E N D E N C Y OF MODULUS AND DAMPING 127

9 STRENGTHS OF COHESIVE SOILS UNDER

12 EVALUATION OF LIQUEFACTION RESISTANCE BY

13 ANALYSIS OF LIQUEFACTION 301

14 SETTLEMENT IN SAND DEPOSITS FOLLOWING

15 FLOW AND NON-FLOW CONDITIONS AND RESIDUAL

16 ONSET CONDITION FOR LIQUEFACTION AND

APPENDIX: METHODS OF SAMPLE PREPARATION 338

A.3 Water sedimentation method 340

You might also like