TDS - Allen Wrench Stanley

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 1

TECHNICAL DATA SHEET (TO BE FILLED UP BY THE MANUFACTURER / BIDDER) Page 1 of 1

DETAILS / PARTS GCGI TECHNICAL REQUIREMENTS BID OFFER

1.01 Name Allen Wrench

1.01 Brand: (Preferred) Stanley

1.02 Measurement In millimeters (mm)

1.03 Quantity Three (3) sets

1.04 Others The other end must be ball point hex.

NOTES:
1. Manufacturer/Bidder shall indicate its compliance to the Technical Requirements of GCGI on the column marked “BID OFFER” by using
ONLY the words “COMPLY” or “FOLLOWED”. Symbols or characters such as “DITTO” or QUOTATION MARKS are NOT
ACCEPTABLE. Should the Bidder deviate from the requirements of GCGI, it shall indicate the exact offer on the space provided.
Supporting documentation must be provided.
2. In case the provided spaces are not enough, use additional sheet and indicate “SEE ATTACHED” on the space provided.
3. Unless otherwise specified, requirements indicated above are minimum.
4. Failure to provide the necessary information/data required in this Technical Data Sheet may cause the disqualification of bid.

Bidder’s Name: Manufacturer’s Name:

Authorized Signatory: Authorized Signatory:

Designation: Designation:

Signature: Signature:

Date: Date:

FOR GCGI USE ONLY


Document Title
GREEN CORE GEOTHERMAL INC.
Instrumentation & Control Section Allen Wrench
Maintenance Department Project Name
Revision Date Description Requisition Number Prepared by Checked by Approved by

0 24/04/2019 Issued For Bid JMMW MCA DTA

You might also like