Hygroscopic Compounds

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 2

Hygroscopic Compounds

These are compounds that absorb or adsorb water vapour from air. Some may absorb so much
water they actually dissolve in the water they have absorbed and one is left with a solution.
Instant coffee granules will do this, left for a few hours, they turn from powder to a gooey
puddle.

Why do some compounds absorb water from air?


Hygroscopic compounds take up water from the air for many different reasons. Here are a few:

 Ionic compounds are often hygroscopic because they form stable hydrates.
 Metal cations (being positively charged) attract the lone pairs on water
oxygens and form coordinate covalent bonds with water. For example,
many divalent cations M2+ can form ions like [M(H2O)6]2+. One or more of
the waters can be replaced with anions in the hydrate.
 Anions like sulfate or nitrate can form strong hydrogen bonds with the
water. For example, nitrate ions form a very stable arrangement with
water in which the water "bridges" the nitrate oxygens with hydrogen
bonds.
 Sometimes both the anion and the cation bind water. For example, in
copper (II) sulfate pentahydrate, four waters are bound in a square
around the copper (II) ion's equator and two sulfates are bound to the
poles. The fifth water bridges sulfates together.
 Some highly soluble ionic compounds go a step further. The shell of waters
formed around the individual ions on the surface of the material becomes an
excellent surface for more waters to bind. This is especially true with small and
highly charged ions like hydroxide. Water will sometimes continue to be added
to the shell until the material actually dissolves in the adsorbed water. This is
called deliquescence. As a student, I remember naively trying to prepare a 0.1000
M NaOH solution by weighing out a tenth of a mole of NaOH on a Mettler
balance. I couldn't get a steady weight; the balance was precise enough to weigh
the water as it was being absorbed from the air. Within a few minutes, I could
see that the surface of the pellets was wet, and within about 15 minutes, the
pellets looked as though they had melted.
 Water molecules can diffuse into the material and become trapped there,
especially if the material contains voids that can hydrogen-bond the water in
place.

Hygroscopic Compounds Page 1


 Some porous materials can absorb large amounts of water by phenomena called
capillary condensation. For example, zeolites (complex sodium aluminum
silicates) are honeycombed with cavities lined with oxygen atoms. Water in air
hydrogen bonds to the outer surfaces of the material. As more water condenses,
it tries to spread out and wet as much of the surface as possible to minimize its
energy through hydrogen-bonding. That carries the water deeper into the
material, making more room for water to adsorb to the outer surface. (They soak
up water like a sponge!)

Some uses of Hygroscopic Compounds


The hygroscopic properties of silica gel are commonly used to keep some foods, drugs and
electronic equipment dry by including little sachets of the silica in the packaging of these
products.

Often, a small amount of cobalt II chloride is added to the silica pellets giving them the
added ability to change colour depending upon how much water they have absorbed. When
completely dry, the pellets are a strong blue colour and when they have absorbed water
they turn a pale pink. Pale pink silica pellets may be returned to blue ones by heating in an
oven, thus rendering them capable of re-use.

Hygroscopic Compounds Page 2

You might also like