Scribd
Upload
96 views4 pages

Design of Colpitts Oscillator

The document describes the design of a Colpitts oscillator circuit. It introduces the Colpitts oscillator and how it generates sinusoidal oscillations using a tank circuit of inductors and capacitors. It then discusses modeling the circuit by selecting resistor and capacitor component values for biasing and the tank circuit. The document shows the RTL schematic designed in ESIM software and simulation outputs of the frequency response plot from NGSPICE and Python. It concludes that the Colpitts oscillator was successfully designed and appropriate waveforms were obtained.

Uploaded by

edgar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
96 views4 pages

Design of Colpitts Oscillator

The document describes the design of a Colpitts oscillator circuit. It introduces the Colpitts oscillator and how it generates sinusoidal oscillations using a tank circuit of inductors and capacitors. It then discusses modeling the circuit by selecting resistor and capacitor component values for biasing and the tank circuit. The document shows the RTL schematic designed in ESIM software and simulation outputs of the frequency response plot from NGSPICE and Python. It concludes that the Colpitts oscillator was successfully designed and appropriate waveforms were obtained.

Uploaded by

edgar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

DESIGN OF COLPITTS OSCILLATOR

T.JEEVA REKHA S.SHUBHAKARINI


DEPARTMENT OF ELECTRONICS AND COMMUNICATION
ENGINEERING
DR.MAHALINGAM COLLEGE OF ENGINEERING AND
TECHNOLOGY, POLLACHI.
Email id:[email protected]

INTRODUCTION:

Colpitts Oscillator is designed for the generation of high


frequency sinusoidal oscillations with the frequencies
ranging from 10 KHz -300MHz.This is bipolar junction
transistor (BJT).
When the power supplies are switched ON the capacitor
starts charging and after the capacitors get fully charged it
Starts discharging through the inductor causing damped
harmonic oscillations. Hence the generation of oscillation
and the frequencies of oscillations are determined by
using the resonant frequency of a TANK circuit consisting
of inductors and capacitors. The capacitors forms potential
divider and this tapped capacitance in the tank circuit can
be used to provide better frequency stability compared to
the Hartley oscillator.

𝑓𝑟 =1/ (2π˨˩ (L*C))


Where
𝑓𝑟 is the resonant frequency.
C is the equivalent capacitance.
L is the self inductance in tank circuit.
MODELLING:

BIASING RESISTOR VALUES:


R1=190k ohms
R2=36k ohms
R3=4.8k ohms
R4=1.2k ohms

TANK CIRCUIT DESIGN:


C4=20n F
C2=5n F
L=50m H

RTL SCHEMATIC USING ESIM SOFTWARE:

FIGURE 1: DESIGN OF COLPITTS OSCILLATOR


SIMULATION OUTPUT:

NGSPICE PLOT:

FIGURE 2: NGSPICE OUTPUT FREQUENCY PLOT


PYTHON PLOT:

FIGURE 3: PYTHON PLOTTING OF OUTPUT

CONCLUSION:
Thus, we have designed colpitt’s oscillator using
esim and we get appropriate waveforms.

REFERENCE:
https://www.elprocus.com/colpitts-oscillator-circuit-working-and-
applications/,referred on 10/01/2018.

You might also like