Scribd
Upload
86 views1 page

RT 31026042019

This document contains questions for a Linear & Digital IC Applications exam. It has two parts - Part A with short answer questions and Part B with longer answer questions. Part A asks about current mirrors, voltage regulators, op-amps, PLL applications, filters, and DAC output calculations. Part B asks about op-amp block diagrams, differential amplifiers, op-amp measurements, voltage regulators, differentiators, log amplifiers, 555 timers, filters, DACs, and DAC specifications. The document provides guidance on the number of marks allocated to each question.

Uploaded by

Syed Ashmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
86 views1 page

RT 31026042019

This document contains questions for a Linear & Digital IC Applications exam. It has two parts - Part A with short answer questions and Part B with longer answer questions. Part A asks about current mirrors, voltage regulators, op-amps, PLL applications, filters, and DAC output calculations. Part B asks about op-amp block diagrams, differential amplifiers, op-amp measurements, voltage regulators, differentiators, log amplifiers, 555 timers, filters, DACs, and DAC specifications. The document provides guidance on the number of marks allocated to each question.

Uploaded by

Syed Ashmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Code No: RT31026 R13 SET - 1

III B. Tech I Semester Supplementary Examinations, May -2019


LINEAR & DIGITAL IC APPLICATIONS
(Electrical and Electronics Engineering)
Time: 3 hours Max. Marks: 70
Note: 1. Question Paper consists of two parts (Part-A and Part-B)
2. Answering the question in Part-A is compulsory
3. Answer any THREE Questions from Part-B
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

PART –A
1 a) Draw and explain the circuit diagram of basic current mirror. [3M]
b) Explain and draw the circuit of a voltage regulator. [4M]
c) Draw the current to voltage converter circuit using op-amp. [4M]
d) What are the applications of PLL [4M]
e) Draw the frequency response characteristics of band elimination filter [3M]
f) The LSB of a 10=bit DAC is 20mv.calculate the output voltage for an input, [4M]
1011001101.
PART -B
2 a) Draw the basic block diagram of op-amp and explain the operation of each block. [8M]
b) With a neat sketch explain the ac analysis of single input unbalanced output [8M]
differential amplifier

3 a) Explain the process of measuring offset voltage and Slew rate in op-amp. [8M]
b) Write short notes on voltage regulators. [8M]

4 a) Draw the circuit diagram of differentiator by using IC 741 and explain its [8M]
operation.
b) Draw the block diagram of log Amplifiers and explain its operation in detail. [8M]

5 a) Explain internal block diagram and operation of 555 timer. [8M]


b) Explain how 555 timer acts as an astable multivibrator. Show that it can generate a [8M]
square wave?

6 a) Design a band pass filter for cut off frequencies 500 Hz and 1.5 kHz with a pass [6M]
band gain of 4.
b) Explain the characteristics of All pass filter and Notch filter. [10M]

7 a) Draw the block diagram of inverted R-2R DAC and explain its operation in detail. [10M]
b) List out the DAC Specifications. [6M]

*****

www.manaresults.co.in

You might also like