RRZZ-65B-R4

8-port sector antenna, 4x 694–960 and 4x 1427–2690 MHz, 65° HPBW,

4x RET
l All Internal RET actuators are connected in “Cascaded SRET
SRET”” configuration

l Uses the 4.3

4.3--10 connector which is 40 percent smaller than the 7
7--16 DIN connector

l Supports re
re--configurable antenna sharing capability enabling control of the internal RET system using
up to two separate RET compatible OEM radios

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1427–1518 1695–1920 1920–2180 2300–2500 2500–2690
Gain, dBi 14.4 14.7 15.1 15.4 17.4 17.7 18.1 17.6
Beamwidth, Horizontal, degrees 68 64 59 68 58 60 60 68
Beamwidth, Vertical, degrees 11.8 10.6 9.7 8.7 7.3 6.4 5.5 5.1
Beam Tilt, degrees 2– 12 2– 12 2– 12 2– 12 2– 12 2– 12 2– 12 2– 12
USLS (First Lobe), dB 16 18 18 17 17 17 18 18
Front
Front--to
to--Back Ratio at 180°, dB 33 32 31 30 39 38 32 29
Isolation, Cross Polarization, dB 28 28 28 28 28 28 28 28
Isolation, Inter
Inter--band, dB 28 28 28 27 28 28 28 28
VSWR | Return Loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -150
Input Power per Port at 50°C,
300 300 300 250 250 250 200 200
maximum, watts
Polarization   ±45° ±45° ±45° ±45° ±45° ±45° ±45° ±45°
Impedance   50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm

Electrical Specifications, BASTA*

Frequency Band, MHz 694–790 790–890 890–960 1427–1518 1695–1920 1920–2180 2300–2500 2500–2690
Gain by all Beam Tilts, average,
14.1 14.4 14.9 15.1 16.9 17.4 17.7 17.1
dBi
Gain by all Beam Tilts
±0.4 ±0.5 ±0.4 ±0.5 ±0.8 ±0.5 ±0.5 ±0.7
Tolerance, dB
2 ° | 14.1 2 ° | 14.5 2 ° | 15.0 2 ° | 15.0 2 ° | 16.9 2 ° | 17.2 2 ° | 17.4 2 ° | 16.7
Gain by Beam Tilt, average, dBi 7 ° | 14.2 7 ° | 14.6 7 ° | 15.1 7 ° | 15.2 7 ° | 17.0 7 ° | 17.5 7 ° | 17.9 7 ° | 17.5
12 ° | 13.8 12 ° | 14.1 12 ° | 14.5 12 ° | 15.0 12 ° | 16.5 12 ° | 17.1 12 ° | 17.5 12 ° | 16.9
Beamwidth, Horizontal
±3.5 ±4 ±5.1 ±4.8 ±5.6 ±3 ±9.2 ±8.4
Tolerance, degrees
Beamwidth, Vertical Tolerance,
±0.8 ±0.8 ±0.7 ±0.4 ±0.8 ±0.6 ±0.3 ±0.3
degrees
USLS, beampeak to 20° above
16 18 17 14 16 15 16 14
beampeak, dB
Front
Front--to
to--Back Total Power at
20 21 22 25 31 27 26 26
180° ± 30°, dB
CPR at Boresight, dB 20 21 24 17 18 20 18 19
CPR at Sector, dB 9 6 8 6 8 5 7 7

* CommScope
CommScope® ® supports NGMN recommendations on Base Station Antenna Standards (BASTA). To learn more about the benefits of BASTA, download the
whitepaper Time to Raise the Bar on BSAs.

Array Layout
page 1 of 4
May 6, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019
RRZZ-65B-R4

 
 

Port Configuration

 
 

General Specifications
Operating Frequency Band 1427 – 2690 MHz   |   694 – 960 MHz

page 2 of 4
May 6, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019
RRZZ-65B-R4

Antenna Type Sector

Band Multiband
Performance Note Outdoor usage
Total Input Power, maximum 900 W @ 50 °C
 

Mechanical Specifications
RF Connector Quantity, total 8
RF Connector Quantity, low band 4
RF Connector Quantity, high band 4
RF Connector Interface 4.3-10 Female
Grounding Type RF connector inner conductor and body grounded to reflector and mounting bracket
Radiator Material Low loss circuit board
Radome Material Fiberglass, UV resistant
Reflector Material Aluminum
RF Connector Location Bottom
Wind Loading, frontal 685.0 N @ 150 km/h
154.0 lbf @ 150 km/h
Wind Loading, lateral 232.0 N @ 150 km/h
52.2 lbf @ 150 km/h
Wind Loading, maximum 889.0 N @ 150 km/h
199.9 lbf @ 150 km/h
Wind Speed, maximum 241 km/h   |   150 mph
 

Dimensions
Length 1828.0 mm   |   72.0 in
Width 498.0 mm   |   19.6 in
Depth 197.0 mm   |   7.8 in
Net Weight, without mounting kit 35.1 kg   |   77.4 lb
 

Remote Electrical Tilt (RET) Information

Input Voltage 10–30 Vdc
Internal RET High band (2)   |   Low band (2)
Power Consumption, idle state, maximum 1W
Power Consumption, normal conditions, maximum 8 W
Protocol 3GPP/AISG 2.0 (Single RET)
RET Hardware CommRET v2
RET Interface 8-pin DIN Female   |   8-pin DIN Male
RET Interface, quantity 2 female   |   2 male
 

page 3 of 4
May 6, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019
RRZZ-65B-R4

Packed Dimensions
Length 2010.0 mm   |   79.1 in
Width 608.0 mm   |   23.9 in
Depth 352.0 mm   |   13.9 in
Shipping Weight 49.0 kg   |   108.0 lb

Regulatory Compliance/Certifications
Agency Classification
RoHS 2011/65/EU Compliant by Exemption
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
China RoHS SJ/T 11364-2014 Above Maximum Concentration Value (MCV)
CE Compliant with the relevant CE product directives

Included Products
BSAMNT--3 — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
BSAMNT
bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

page 4 of 4
May 6, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019