Scribd
Upload
38 views2 pages

Installing Windows Server 2008 DHCP Server: / Roles / Add Roles

The document provides instructions for installing the DHCP Server role in Windows Server 2008. It explains that DHCP Server is now a role rather than a component. It outlines the information needed for installation, including the network IP range and DNS servers. It describes starting the installation process by adding roles in Server Manager and selecting DHCP Server. It notes the option to configure basic settings and scopes during installation or complete installation first before configuration.

Uploaded by

thess22
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
38 views2 pages

Installing Windows Server 2008 DHCP Server: / Roles / Add Roles

The document provides instructions for installing the DHCP Server role in Windows Server 2008. It explains that DHCP Server is now a role rather than a component. It outlines the information needed for installation, including the network IP range and DNS servers. It describes starting the installation process by adding roles in Server Manager and selecting DHCP Server. It notes the option to configure basic settings and scopes during installation or complete installation first before configuration.

Uploaded by

thess22
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Installing Windows Server 2008

DHCP Server
Installing Windows Server 2008 DCHP Server is easy. DHCP Server is
now a “role” of Windows Server 2008 – not a windows component as it
was in the past.
To do this, you will need a Windows Server 2008 system already installed
and configured with a static IP address. You will need to know your
network’s IP address range, the range of IP addresses you will want to
hand out to your PC clients, your DNS server IP addresses, and your
default gateway. Additionally, you will want to have a plan for all subnets
involved, what scopes you will want to define, and what exclusions you
will want to create.
To start the DHCP installation process, you can click Add Roles from
the Initial Configuration Tasks window or from Server Manager
/ Roles / Add Roles.

Figure 1: Adding a new Role in Windows Server 2008


When the Add Roles Wizard comes up, you can click Next on that screen.
Next, select that you want to add the DHCP Server Role, and click Next.
Figure 2: Selecting the DHCP Server Role
If you do not have a static IP address assigned on your server, you will get
a warning that you should not install DHCP with a dynamic IP address.
At this point, you will begin being prompted for IP network information,
scope information, and DNS information. If you only want to install
DHCP server with no configured scopes or settings, you can just
click Next through these questions and proceed with the installation.
On the other hand, you can optionally configure your DHCP Server during
this part of the installation.
In my case, I chose to take this opportunity to configure some basic IP
settings and configure my first DHCP Scope.
I was shown my network connection binding and asked to verify it, like
this:

You might also like