Scribd
Upload
1K views1 page

Micro20 Error Codes

This document lists error codes and their meanings for a Micro20 appliance. Codes beginning with E refer to specific issues like a locked door, programming errors, or sensors not reaching set levels. Codes beginning with Not indicate the motor overload protector tripped. Codes LeU and SLE mean water remained in the tub at the end of the cycle.

Uploaded by

eduardo_barreto_54
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
1K views1 page

Micro20 Error Codes

This document lists error codes and their meanings for a Micro20 appliance. Codes beginning with E refer to specific issues like a locked door, programming errors, or sensors not reaching set levels. Codes beginning with Not indicate the motor overload protector tripped. Codes LeU and SLE mean water remained in the tub at the end of the cycle.

Uploaded by

eduardo_barreto_54
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Micro20 Error Codes

----- Door is locked prior to start


E3 Possible Eprom problem or E-Eprom
E3 1 Probable vend pricing error
E3 2 Probable vend pricing error
E3 3 Probable vend pricing error
E3 4 Probable vend pricing error
E3 5 Probable vend pricing error
E3 6 Probable vend pricing error
E3 7 Probable vend pricing error
E3 8 Probable vend pricing error
E3 9 Probable vend pricing error
E4 The programmed water level was not reached in 15
minutes
E5 The programmed temperature was not reached in 80
minutes
E6 The door lock was released during operation
E7 Water did not drain and extract/spin was not achieved
E8 Temp sensor problem
E9 Motor overload protector tripped
EA The Tilt switch was tripped several times during the
program
Eb The Tilt switch is out of its slot in the bracket or broken
Not Motor overload protector tripped
Not 2 Speed sensor output does not match programmed speeds.
(Freq Drive machines only)
LeU Water is still in the tub at the end of the cycle
SLE Water is still in the tub at the end of the cycle

You might also like