Dynatex Dielectric 49634
Dynatex Dielectric 49634
Dynatex Dielectric 49634
Section 1. Identification
Manufacturer Contact
Address Dynatex a division of Soudal Accumetric
350 Ring Road
Elizabethtown, KY, 42701
USA
Classification N/A
Signal Word
Pictogram
Hazard Statements N/A
Precautionary Statements
Response N/A
Prevention N/A
Storage N/A
Disposal N/A
Ingredients of unknown 0%
toxicity
Page 1 of 5
Hazards not Otherwise
Classified
Additional Information None known
Section 3. Ingredients
CAS Ingredient Name Weight %
112945-52-5 Amorphous fumed silica 5% - 15%
Eye Contact Immediately flush eyes with water for at least 15 minutes. Get medical
attention if irritation develops.
Skin Contact Remove contaminated clothing and wash skin with soap and water. Get
medical attention if irritation persists. Launder clothing before reuse.
Ingestion DO NOT INDUCE VOMITING. Seek immediate medical attention.
Inhalation The vapor pressure is very low. Vapor inhalation under ambient conditions is
normally not a problem. If overcome by vapor from hot product, immediately
remove from exposure and seek medical attention. If breathing has stopped,
start resuscitation; administer oxygen if breathing is irregular. If overexposed to
oil, remove from further exposure until excessive mist conditions subside.
Steps to be taken in case Recover free product. Add sand, earth or other suitable absorbent to spill area.
of spill or release Minimize skin contact. Keep product out of sewers and watercourses by diking
or impounding. Advise authorities if product has entered or may enter sewers,
watercourses or extensive land areas. Assure conformity with applicable
governmental regulations. Spilled material, unused contents and empty
containers must be disposed of in accordance with local, state and federal
regulations.
Page 2 of 5
Section 7. Handling and Storage
Handling Do not mix with strong oxidizers. Keep out of eyes. Always wash hands well
before touching face or eating.
Storage Do not store sealed container near extreme heat. Do not reuse container. Do
not store near strong oxidizers.
Page 3 of 5
Flammability N/A
Decomposition Temperature N/A
Auto-ignition Temperature N/A
Vapor Pressure < 5 mm Hg
@ 25C
Vapor Density >1
Note The above information is not intended for use in preparing product
specifications. Contact Soudal Accumetric before writing specifications.
Chemical Stability This product is stable and will not react violently with water.
Hazardous polymerization Will not occur
Conditions to Avoid None known
Materials to Avoid Strong oxidants such as liquid chlorine, concentrated oxygen, sodium
hypochlorite or calcium hypochlorite.
Hazardous Decomposition Not determined
Products
Waste Disposal Method We make no guarantee or warranty of any kind that the use or disposal of this
product complies with all local, state, or federal laws. It is also the obligation of
each user of the product mentioned herein to determine and comply with the
requirements of all applicable statutes.
Page 4 of 5
federal, local and state laws.
UN Number N/A
UN Proper Shipping Name N/A
DOT Classification N/A
Packing Group N/A
TSCA Status All chemical substances found in this product comply with the Toxic
Substances Control Act inventory reporting requirements.
SARA Title III Section 302 None
Extremely Hazardous
Substances
SARA Titre III Section 304 None
CERCLA Substances
dangereuses
SARA Title III Section No components subject to 40 CFR 370
311/312
SARA Title III Section 313 Contains less than 1% total zinc compounds.
Toxic Chemicals
California Proposition 65 This product contains the following chemical(s) listed by the State of California
under the Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition
65) as being known to cause cancer, birth defects or other reproductive harm:
None known
WHMIS Not a controlled product. Chemical components listed on the DSL inventory.
Disclaimer The data contained herein is based upon information that Soudal Accumetric
believes to be reliable. Users of this product have the responsibility to
determine that suitability of use and to adopt all necessary precautions to
ensure the safety and protection of property and persons involved in said use.
All statements or suggestions are made without warranty, expressed or
implied, regarding the accuracy of the information, the hazards connected with
the use of the material or the results to be obtained from the use thereof.
Page 5 of 5