Scribd
Upload
775 views8 pages

Nts Past Paper

The document contains 100 multiple choice questions from an NTS past paper. It covers topics in electricity, electronics, power systems, signals and systems, and computer science. The questions test knowledge of concepts like polarization, waveforms, circuit configurations, control systems, partial differential equations, and more.

Uploaded by

Muhammad Rizwan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
775 views8 pages

Nts Past Paper

The document contains 100 multiple choice questions from an NTS past paper. It covers topics in electricity, electronics, power systems, signals and systems, and computer science. The questions test knowledge of concepts like polarization, waveforms, circuit configurations, control systems, partial differential equations, and more.

Uploaded by

Muhammad Rizwan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

Nts Past Paper

18 -the electric dipole moment induced per unit volume of the dielectric
is called the
 Polarization of dielectric

19-the negative maximum of a cosine waveform occurs at


 180
20-for current amplification in bjt we mostly use
 Common Emitter configuration
21-if we have two point “A” and “B” on node and the voltage is
represented by VAB, the is taken as reference.
 Node “A”
22-The form factor of a 220v, 50HZ AC waveform is
 1.11
23-stepper motor is a/an motor which divides full rotation into large
number of steps
 Alternating Current
24-n type material is formed by doping pure silicon with
 N-type pentavalent
 P-type Trivalent
25-the main criterion for selection of the size of a radial distribution
system is
 Voltage drops
26-self induction of solenoid is
 Directly proportional to the current flowing through the coil
27-transmission lines mostly use high voltage alternating current
 Three Phase
28-in a dc generator the brushes on the commutator are shifted from
geometric to neutral position to
 Avoid the Sparking
29-the field lasts only as long as the current is flowing through the wire
 Electric Field
30-the triac is device with control terminal
 Bi-direactional
31-if all conductive objects are bonded to the same earth ground system
the risk of electric shock is
 Minimized
32-in an open loop control system output is ------of control input
 independent
33- if a is a square matrix with 3×3 order having det(A)=21,than what will
be the det(2A)?whereas 'det is the determinant
 (2)^3×21=168
34- error in a computer program is called
 Bug
35- a system is if the natural response neither decays nor grows , but
remains constant or oscillates
 Marginally Stable
36- the partial derivatives fxy and fyx are called
 Mixed partial
37- green function method is a useful technique for solving
 Partial Differential Equation
38- the sum of all potential differences in a complete loop through the
circuit should be
 Equal To zero
39- the unguided propagation involves
 Free Space Propagation
40- preferring a consists of using ohms to take an existing voltage source
in series with a resistance and replace it with current source in parallel
with the same resistance
 Source Transformation
41- dynamic resistance of diode change
 Changes as a function of applied voltage
46- The line integral of the electric field around any closed loop is equal
to minus the time rate of change of the magnetic flux through the loop.
 Maxwell’s Equations
47-Conductors have an excess of
 Free Electrons
54- Fourier series are infinite series of elementary trigonometric functions
i.e sine and
 Cosine
55-The process of conversion of AC into DC is Called
 Rectification
56- the principle of can be used to analyze fault in power system/network
 Superposition
57-scr (silicon controlled rectifier) goes into saturation when gate-cathode
junction is
 Reverse Biased
58-drop out to cutoff ratio for most relays is of the order of
 0.6 to 1.0
59-a copper-oxide allows current to a flow through a meter in only one
direction
 Rectifier
60-main purpose of modulation process is to
 Reduce the mutual Interference
61-which line is obtained by method of least square
 Straight line
62-a transformer transforms
 Power
63-conjunction x^y behaves on digits 0 and 1 exactly as does for ordinary
Algebra
 Multiplication
64-power in ac circuit is found by
 VIcos∞
65-are used to sense the fault and initiate a trip
 Protective relays
66-modulation index in amplitude modulation
 the measure of extent of amplitude variation about an un-modulated carrier

68-These are of four types depending on the controlling variable and output of the source.
69-discrete device field effect transistor is classified on the basis of their
 Conducting State
70-if the current and voltage are out of phase by 90 degree the power is
 Zero
71-at very sunny places this source of energy can be found
 Solar
72-as compared to oscillators an inverter provides
 Low voltage
75-if firing angle in a scr rectifier is decreased output is
 Increased
76-the continuous time signal is described for all values of time
77-depletion region of diode contains
 No Mobile Charge Carriers
78-which of the following conditions relates line resistance R and line
reactance "X" for maximum steady state power transmission on a
transmission line
 X=R
81-the waves which do not need material medium for their propagation
 Electromagnetic waves
82-is a by product of paper production industry which used by many
industries as primary source of electricity
 Wood waste,landfill gas
83-which of the following ideas means deciding at runtime what strategy
to summon
 Dynamic blinding
84-in superposition theorem independent current sources are replaced by
 current sources with an open circuit
 voltage sources with a short circuit

86-which wave has the highest value of form factor


 Sqaure wave
87-the analog to digital converter provide of input signal
 All information
88-the form of reference to alternating current waveform represents the
ratio
 RMS value to the average value
89-a semiconductor device is connected in series circuit with a battery and
a resistance . if the polarty of battery is reverved the current drops almost
to zero the device may be
 A P-n Junction
90-what is the probability of number "2" when a dice is thrown
 1/6
91-for which purpose bundled conductors are employed to a power
system
 Reduce corona
92-radio frequency chokes are air-cored to

 Keep inductive reactance high


93-Fundamental property used in single node pair circuit
analyzer is that _______ across all is same?
 Voltage
94-small voltages (less than 10v) that can be measured between two
possible constant points
 Stray Voltage
95-the average fossil fuel plants converts about of these going in to power
going out
 33
96-landfill gas is actually used in thermal power
 Methane
97-power factor of the magnetizing component of a transformer is
 0.8lagging
98-the pole shoes of dc machines are fastened to the pole core by
 Countersunk screwa
99-which pf following are considered as the disadvantage of gauss-seidel
method over newton's method in load flow programs

100-the quantity rm which relates dependent voltage to controlling current


is called
 Trans conductance

You might also like