Scribd
Upload
113 views

Problem Solving Machine Design 2

machine design Problem

Uploaded by

maloy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
113 views

Problem Solving Machine Design 2

machine design Problem

Uploaded by

maloy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
Page tof 3 1. Alocal utility vehicle production company has considered to use in one ofits design a multi-dise clutch consisting of 7 steel discs and 5 bronze disc, with effective outside and inside diameter of 260mm and 16¢mm respectively, Ifthe shaft turns at 1500 rpm and an axial force of 16OON is applied, find the horsepower capacity considering a coefficient of friction of 025. Given do 260m te = 160 en N= 1500 cpm Ta = 160010 ee Reqien ing te +12 (625) (ton) (6287) Silobon = S13. 82. Nn peartn Pe ROG7G ee Yh au oer | February 08,2013. Page2of3 2. Compute the torque required that a clutch must transmit to accelerate the pulley in the figure from rest to 550 rpm in 2.5 sec. Given Te = in Regio, 2 {$= 9 Since D-T9St one ys ng Tacg “=4(o-a Gseibay(or9d) [roast Febuary 03,2013 Page of3 3. Compute the dimensions of annular plate type brake to produce a braking torque of 300 Ib.in. Springs will provide a normal force of 320Ib. between the friction surfaces. The coefficient of friction is 0.25. The brake will be used in average industrial service, stopping a load from 750 rpm, Cie N= 320 ty T= 200 lb in J+ 9.25 Reqiino February 09,2013

You might also like