Scribd
Upload
248 views1 page

Flange Coupling 4

The document instructs the reader to disassemble the parts of a protected flange coupling and draw scaled views of two parts - Flange A and Rectangular sunk taper key A - keeping their positions relative to the horizontal and vertical planes the same as shown in the figure. It specifies which views to draw of each part and asks the reader to print the title, scale, and projection symbol for each drawing and include six important dimensions.

Uploaded by

Sethu Raman Annamalai
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
248 views1 page

Flange Coupling 4

The document instructs the reader to disassemble the parts of a protected flange coupling and draw scaled views of two parts - Flange A and Rectangular sunk taper key A - keeping their positions relative to the horizontal and vertical planes the same as shown in the figure. It specifies which views to draw of each part and asks the reader to print the title, scale, and projection symbol for each drawing and include six important dimensions.

Uploaded by

Sethu Raman Annamalai
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Figure

shows the assembly of a Protected Flange Coupling. Disassemble the parts


and then draw its views of the following parts to scale 1:1. Keep the same position of
both Flange A and Rectangular sunk taper key A with respect to H.P and V.P.
i. FLANGE A:
a. Front view, upper half in section.
b. Side view looking from left.
ii. Rectangular sunk taper key A:
a. Front view.
b. Top view.
Print the title of both and the scale used. Draw the projection symbol. Give 6
important dimensions.

You might also like