Scribd
Upload
695 views32 pages

BS 1873 PDF

Uploaded by

SimranjitSingh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
695 views32 pages

BS 1873 PDF

Uploaded by

SimranjitSingh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 32
BRITISH STANDARD CONFIRMED NOVEMBER 1983 Specification for Steel globe and globe stop and check valves (flanged and butt-welding ends) for the petroleum, petrochemical and allied industries UDC 621.046.2:008.14:(622 828 + 662 758 + 665.6] NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW nll BS 1873:1975 Incorporating Amendment No. 1 i ‘This British Standard, having been approved by the Petrolenum Equipment Industry Standards Committee, was pubhshed. under the authority of the Exceutive Board on 80 April 1975 © BSI 09-1999 First published July 1952 First revision March 1960 Second revision April 1975 The following BSI references relate to the work on this ‘standard: Committee reference PEE/1 Draft for comment 72/35873 DC ISBN 0 580 08502 3 Co-operating organizations The Petroleum Equipment Industry Standards Committee, under whose supervision this British Standard was prepared, consists of representatives from the following Government departments and scientific and industrial organizations: British Gas Corporation British Mechanical Engineering Confederation British Rubber Manufacturers’ Association Ltd. British Steel Industry* Council of British Manufacturers of Petroleum Equipment* Department of Trade and Industry Oil Companies Materials Association* The organizations marked with an asterisk in the above list, together with the following, were directly represented on the Committee entrusted with the preparation of this British Standard: Association of Hydraulic Equipment Manufacturers British Chemical Engineering Contractors’ Association British Industrial Measuring and Control Apparatus Manufacturers’ Association British Plastics Federation British Ship Research Association British Valve Manufacturers’ Association Engineering Equipment Users’ Association Steel Castings Association Amendments sued since publication Amd.No. | Date ofissue | Comments 6664 July 1990 _| Indicated by a sideline in the margin BS 1873:1975 Contents Page Co-operating organizations Inside front cover Foreword iii Section 1. General ae Scope 1 2 References 1 3 Nomenclature 1 4 Pressure classification 1 5 Pressure/temperature ratings 1 6 Nominal sizes 1 7__ Information to be supplied by the purchaser 1 Section 2. Design 8 Body 2 = Bonnet 12 10 Disk, disk nut and disk thrust plate 13, 11 Yoke 13 12 Handwheel 13 13 Stem and yoke bushes 13 14 Stuffing box. packing and lantern ring 13 15 Bolting 1B 16 Operation 15, 17 Bypass 15 18 Soft seal rings 15, Section 3. Materials 19 Shell 20 Body seat rings 21 Bonnet gasket 22 Disk 23° Yoke 24 ~~ Disk thrust plate 25 Handwheel or chainwheel 26 Handwheel or chainwheel nut 27 Yoke bush 28 Yoke bush retaining nut 29 Gland 30 Trim 31 Lantern ring 32 Stem packing 33 Bolting 34 Plugs 35 Nameplate 36 Soft seals 37 _ Special applications Section 4. Marking 38 Required markings 39 Body and nameplate markings 40 Body and bonnet markings 41 Nameplate markings 42 Additional markings 19 19 19 19 19 ‘BST 09.1999

You might also like