Scribd
Upload
27 views1 page

Joint Coordinates: Modelling Methods

This document outlines different modeling methods for joint coordinates and member incidences in structural modeling software. It describes using tables, editors, grid snap, copy and paste, and wizards to define node locations and connect beams to nodes. It also provides examples of renumbering nodes and beams by floor or all at once and starting the new numbering at different base values.

Uploaded by

Jonathan Sanchez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
27 views1 page

Joint Coordinates: Modelling Methods

This document outlines different modeling methods for joint coordinates and member incidences in structural modeling software. It describes using tables, editors, grid snap, copy and paste, and wizards to define node locations and connect beams to nodes. It also provides examples of renumbering nodes and beams by floor or all at once and starting the new numbering at different base values.

Uploaded by

Jonathan Sanchez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Modelling Methods

Joint Coordinates
1. Using Table
Node X Y Z 5 5 6
1 0 0 0
2 0 3 0
3 4 3 0 4 6
4 4 0 0
2 2 3
2. Using Editor
Node
5 0 6 0 1 3
6 4 6 0

1 4
Member Incidences
1. Using Table
Beam
1 1 2
2 2 3
3 3 4
2. Using Editor
Beam
5 5 6
6 6 3

3. Using Grid Snap
4. Using Copy & Paste
5. Using Translational Repeat
6. Using Structure Wizard

Model Management/ Re‐numbering
Nodes Renumber Columns Renumber
All 600 Base 600
Base 1 GF 700
GF 100 1F 800
1F 200 2F 900
2F 300 RD 1000
RD 400
Parapet 500

Beams Renumber
All 1000
GF 100
1F 200
2F 300
RD 400
Parapet 500

You might also like