Scribd Logo
Upload

Welcome to Scribd!

  • 8 views

    Publication Number Platform Section Title Change Page Number(s)

    Uploaded by

    Cuong Dinh
    troi

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Publication Number Platform Section Title Change Page Number(s)

    Uploaded by

    Cuong Dinh
    8 views4 pages
    troi

    Original Title

    402-10

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    troi

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    8 views4 pages

    Publication Number Platform Section Title Change Page Number(s)

    Uploaded by

    Cuong Dinh
    troi

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 4

    NUMBER: 5–01–10 S.M. REF.

    : Listed in Table ENGINE: DD Platform DATE: May 2010

    SUBJECT: 2010 MCM SPN 110 FMI 14 (COOLANT TEMPERATURE / ENGINE OIL
    TEMPERATURE PLAUSIBILITY FAULT)

    ADDITIONS, REVISIONS, OR UPDATES


    Publication Number Platform Section Title Change Page Number(s)
    DDC-SVC-MAN-0084 EPA10 DD Platform 23.6 SPN 110/FMI 14 SPN 110 FMI 14 has 357
    been added.
    NOTE: Page numbers are based on the most recent version of the individual publication and may be adjusted throughout the annual print cycle.
    SPN 110/FMI 14
    This diagnostic is typically Coolant Temperature / Engine Oil Temperature Plausibility Fault.
    1. Are any cooling system issues present?
    [a] Yes; repair cooling system issues first.
    [b] No; go to Step 2.
    2. Check engine oil level. If low fill as necessary.
    3. Start engine and bring to operating temperature to 185°F (85°C).
    4. Does engine reach operating temperature 185°F (85°C)?
    [a] Yes; go to Step 5.
    [b] No; service the cooling system thermostat.
    5. Shut engine OFF (key OFF, engine OFF).
    6. Disconnect coolant outlet and oil temperature sensors.
    7. Inspect the coolant outlet and oil temperature sensor harness connectors for bent, spread or
    corroded pins.
    [a] If pin damage is found, repair as necessary.
    [b] If no pin damage is found, go to Step 8.
    8. Check coolant outlet and oil temperature sensor resistances. Refer to chart for specifications;
    replace sensor which is out of range.
    Resistance Resistance Resistance Nominal Voltage Low Voltage High
    Temp (°C) Temp (°F)
    (Ω) Nominal Low (Ω) High (Ω) Voltage (V) (V) (V)
    0 32 5872.8 5496.4 6249.2 2.56 2.51 2.61
    10 50 3769 3640.3 3897.7 2.37 2.33 2.41
    20 68 2480.7 2260.0 2701.4 2.14 2.05 2.22
    30 86 1693.2 1613.4 1773.0 1.89 1.83 1.95
    35 95 1401.1 1338.4 1463.8 1.75 1.69 1.81
    40 104 1166.8 1117.5 1216.1 1.62 1.56 1.67
    50 122 829.5 798.2 860.8 1.36 1.30 1.41
    60 140 593.8 574.5 613.1 1.12 1.07 1.17
    70 158 435.4 423.1 447.7 0.91 0.86 0.95

    Table 1 Coolant Sensor Resistance Chart


    ADDITIONAL SERVICE INFORMATION
    Additional service information is available in Power Service Literature.

    Detroit Diesel®, DDC®, Series 60® and the spinning arrows design are registered trademarks of Detroit Diesel Corporation.
    © Copyright 2010 Detroit Diesel Corporation. All rights reserved. Printed in U.S.A.

    You might also like