Growing Black Pines For Bonsai PDF

Growing Black Pine for Bonsai
by Brent Walston
Introduction
I am always giving this subject a lot of thought. I consider the training of

black pines, Pinus thunbergii, to be one of the most difficult aspects of
bonsai, as well as one of the slowest goals to achieve. After over fifteen
years of playing with them, I am only now beginning to get to the
ramification stage, and I emphasize 'beginning'. Of course I am not talking
about one inch trunk Shohin here, but full blown three inch trunk
monsters like you see in the books. Most of the finest ones I have had the
privilege to see have been in training for approximately fifty years or
more. This seems to be the general minimum age for really fine trees. I
think it can be done faster than that, but it is still a long term struggle, not
the least of which is the learning curve.
I have now classified the techniques into three basic categories. These
are based on the physiology of the plant's growth response to pruning.
Understanding the response to pruning gives you the tools to design and
train your tree.
Removing Candles in their Entirety
This is the pruning technique that John Naka suggests and the one I have
mostly relied upon to shape my trees. It is slow but gives the most refined
growth. Removing a candle at its base will stimulate the dormant buds in
that node (whorl) primarily. These buds will produce shorter secondary
candles, the length depending mostly on the timing of the pruning. Prune
early and they will be long, prune late and they will be short.
You can manipulate this principle to get just the right size candles for the
next branch extension. Timing can vary even within the same tree. Prune
the candles of the lower, weaker branches early for longer secondary
candles, prune the upper, stronger candles later to slow down the growth
of its secondary candles. In this fashion you can balance the growth of
the tree and make the new growth even or shorter in the top of the tree
for a finer apex.
Pruning candles back to the node will always produce mature, typical
wood. That is what I like about this technique. You can rely upon the
response to produce fairly short needles with strong nodal response, that
is, there will a strong node at the base of the candle and at its tip (the
following season). This is in contrast to juvenile growth discussed below.
Pruning Below or Between Nodes
Pruning between nodes gives a different response, and in general

produces atypical, juvenile growth. Juvenile growth arises not from a
dormant bud at the node, but from an adventitious bud along the
internode at the base of a needle. The color is typically bluer, the needles
finer, stem slightly wavy and thin. After a year of two (after the needles
are gone) this juvenile growth will be indistinguishable from stems of
mature growth.
This kind of pruning can be thought of as 'forcing growth', or forcing the

stem to back bud. It is pretty reliable as long as the needles are still
present on the remaining stem section. Removing the node and its
terminal buds removes the flow of auxin that keeps the adventitious buds
dormant. This releases the buds at the base of the needles, and often it
releases almost ALL of them, so a typical response is produce a 'broom
like' effect with very many shoots just below the cut, one for each needle.
This kind of pruning can be used when you have branch or branch
section in just the right spot, but the internodal distance is too great. To
save and use the branch you have to make a bud break somewhere in the
middle so you can prune it back. The object in training any of the
branches of a black pine is to produce a series of forked branches with
the length of each fork DIMINISHING as they proceed toward the end of
the branch. This is usually accomplished by timing the secondary
candles as explained above. However, sometimes you blow it, or you
acquire a pine with branches in the right position, but with internodes are
too long, particularly the first internode.
If there are still needles on the section you want to stimulate, simply cut
the branch off just before the node (whorl) at the end of this section. I
usually do this in late winter, but I don't think the timing is all that
important. This is another fuzzy area for me, and I will probably know the
answer in another five years. I did learn one new trick though. A
colleague of mine prunes in late winter as I do, but doesn't prune the
needles until later, usually in July. Removing the tips of the needles
further reduces the auxin flow and will help in releasing the adventitious
buds. It certainly works for him, he creates branch stubs with little fuzz
balls at the end of them after one year. So cut the needles in half on the
remaining branch stub in summer. New buds will be evident by fall.
If the section you want to stimulate doesn't not have needles (older
wood) you cannot use the above procedure. Conifers are very sensitive
to the hormone feedback system between the roots and the branches. I
think this partly due to the long lag time (much longer than deciduous
plants) for bud break. Strongly growing branches send the hormone
auxin to the roots (actually specific roots) which stimulates those roots to
increase their growth to support the new foliage. Roots thus stimulated
send more of the hormone cytokinin to the branch to stimulate stronger
branch and foliage growth. If the roots fail to receive the auxin signal
which is produced by the terminal buds and foliage, they will cut off the
cytokinins and eventually wall off the area causing the branch to die.
This is what we call 'keeping a sap line' in conifers. It is true of some

other plants as well, but is critical for conifers. That is why you hear the
warning about always leaving some foliage at the end of each branch
when pruning pines and junipers.
So what do you do to stimulate buds in older wood where the needles

have long since fallen? You can start 'forcing' the growth back by starting
farther up the tree, or farther out on the limb. Prune just ahead of a node
that DOES have needles left on it. This will stimulate bud breaks before it.
In addition it will often produce a very few adventitious breaks on the
older wood in the internodes (or nodes) in the needleless sections. Once
these buds break, be very careful with them, they will be extremely
fragile, and it probably won't happen twice. Let them grow undisturbed
for two years, then begin forcing growth on them. After a few more years,
you may be able to force growth back even farther by hard pruning of
these stems.
The key to a strong bud breaking response is to have a very vigorously

growing plant. There must be a strong root system and strong upper
growth as well. Before doing any of this work, invigorate the plant by
repotting it, or planting it in the ground, giving it optimum water and
sunlight, and fertilize it adequately. Alternate heavy pruning years with
light pruning years to allow the plant to 'pump up'.
Pruning Between Candles
I haven't done much of this, since I was so strongly influenced by Naka,

but apparently Ernie Kuo has done a lot of it and has published an article
on it. Many people remove only part of the candle instead of the candle
at its base to achieve ramification. They might even remove various
fractions of the candles, one half, one third, two thirds, etc. The object
here is not necessarily to stimulate new shorter secondary candles from
the node, but to use existing candles that would otherwise be too long.
By cutting the candle you stimulate the adventitious buds at the base of
the new needles near the end of the cut and you will get two or more bud
breaks in the same season. Ernie uses this technique to get more than
one set of forked branches (ramification) in a single season. I think this
technique is probably best suited for warm, long growing season areas.
And finally
There are also some general growth issues for training black pine and
design considerations that must be tailored to these pruning techniques.
These are addressed in the companion article to this piece: Training
Black Pine for Bonsai
copyright 2001, all rights reserved
Articles Home Page Images Email Order Form Plant Catalog

Growing Black Pines For Bonsai PDF

Uploaded by

Copyright:

Available Formats

Growing Black Pines For Bonsai PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Growing Black Pines For Bonsai PDF

Uploaded by

Copyright:

Available Formats

What are the three basic pruning techniques described for training black pine?

What effect does pruning between nodes have compared to pruning at nodes?

Growing Black Pine for Bonsai

I am always giving this subject a lot of thought. I consider the training of

Removing Candles in their Entirety

Pruning Below or Between Nodes

Pruning between nodes gives a different response, and in general

This kind of pruning can be thought of as 'forcing growth', or forcing the

This is what we call 'keeping a sap line' in conifers. It is true of some

So what do you do to stimulate buds in older wood where the needles

The key to a strong bud breaking response is to have a very vigorously

Pruning Between Candles

I haven't done much of this, since I was so strongly influenced by Naka,

copyright 2001, all rights reserved

Articles Home Page Images Email Order Form Plant Catalog

You might also like