Scribd
Upload
25 views1 page

Description: Ecad LAB#8 24-5-2013

This document describes how a student drew a 2D figure in AutoCAD using basic commands. The student gave commands like @3 <90 to specify a length of 3 and angle of 90 degrees. Angles of 30, -30, 150, and -150 degrees were used to draw the figure. The document also includes identification information for the student who created the drawing.

Uploaded by

RANA RAMEEZ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
25 views1 page

Description: Ecad LAB#8 24-5-2013

This document describes how a student drew a 2D figure in AutoCAD using basic commands. The student gave commands like @3 <90 to specify a length of 3 and angle of 90 degrees. Angles of 30, -30, 150, and -150 degrees were used to draw the figure. The document also includes identification information for the student who created the drawing.

Uploaded by

RANA RAMEEZ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

ECAD LAB#8 24-5-2013

Description
The basic technique that I used to draw this figure in AUTO CAD is by
giving commands for example; @3 <90 ,where 3 is length and 90 is
angle. I used angles 30,-30,150,-150 to draw this 2-D figure.

Sohail AKhtar 12-EE-133 A2

You might also like