Scribd
Upload
126 views2 pages

Mq2 Gas Sensor Module

The MQ2 gas sensor module can detect gases like LPG, propane, and hydrogen. It uses an SnO2 sensor that has lower conductivity in clean air but provides an analog output based on the concentration of detected gases like smoke. The sensor is connected in a voltage divider circuit with a variable resistor to allow adjusting sensitivity. It operates on 4.5-5V and can detect combustible gases in the range of 300-10,000ppm. Applications include monitoring air quality and safety in homes.

Uploaded by

Apri Ega
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
126 views2 pages

Mq2 Gas Sensor Module

The MQ2 gas sensor module can detect gases like LPG, propane, and hydrogen. It uses an SnO2 sensor that has lower conductivity in clean air but provides an analog output based on the concentration of detected gases like smoke. The sensor is connected in a voltage divider circuit with a variable resistor to allow adjusting sensitivity. It operates on 4.5-5V and can detect combustible gases in the range of 300-10,000ppm. Applications include monitoring air quality and safety in homes.

Uploaded by

Apri Ega
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MQ2 Gas Sensor Module

MQ2 gas sensor can be used to detect the presence of LPG, Propane and Hydrogen, also
could be used to detect Methane and other combustible steam, it is low cost and suitable for
different application. Sensor is sensitive to flammable gas and smoke. Smoke sensor is given 5
volt to power it. Smoke sensor indicate smoke by the voltage that it outputs .More smoke more
output. A potentiometer is provided to adjust the sensitivity. Sn02 is the sensor used which is of
low conductivity when the air is clean. But when smoke exist sensor provides an analog
resistive output based on concentration of smoke. The circuit has a heater. Power is given to
heater by VCC and GND from power supply. The circuit has a variable resistor. The resistance
across the pin depends on the smoke in air in the sensor. The resistance will be lowered if the
content is more. And voltage is increased between the sensor and load resistor.

Board Schematic
SPECIFICATIONS

 Power Supply: 4.5V to 5V DC


 High sensitivity to Propane, Smoke, LPG and Butane
 Wide range high sensitivity to Combustible gases
 Long life and low cost
 Analog and Digital output available
 Onboard visual indicator (LED) for indicating alarm
 Compact design and easily mountable
 Simple 4 PIN header interface
 Drive circuit is simple.
 Sensor Type : Semiconductor
 Concentration : 300-10000ppm ( Combustible gas)
 Supply voltage =5v

APPLICATIONS

 Safety of home
 Control of air quality
 Measurement of gas level

Working Principle
The MQ2 has an electrochemical sensor, which changes its resistance for different
concentrations of varied gasses. The sensor is connected in series with a variable resistor to
form a voltage divider circuit (Fig 1), and the variable resistor is used to change sensitivity.
When one of the above gaseous elements comes in contact with the sensor after heating, the
sensor’s resistance change. The change in the resistance changes the voltage across the sensor,
and this voltage can be read by a microcontroller. The voltage value can be used to find the
resistance of the sensor by knowing the reference voltage and the other resistor’s resistance.
The sensor has different sensitivity for different types of gasses.

You might also like