0% found this document useful (0 votes)
151 views2 pages

Output P543

The document defines and provides time charts for several logic timer symbols used in relay protection devices, including delay on pick-up timers, delay on drop-off timers, pulse timers, dwell timers, and latching versus straight (non-latching) logic. Logic timers are used to control the timing of output relay operations based on input signals and adjustable time settings.

Uploaded by

Noptana Tummasit
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
151 views2 pages

Output P543

The document defines and provides time charts for several logic timer symbols used in relay protection devices, including delay on pick-up timers, delay on drop-off timers, pulse timers, dwell timers, and latching versus straight (non-latching) logic. Logic timers are used to control the timing of output relay operations based on input signals and adjustable time settings.

Uploaded by

Noptana Tummasit
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Symbols and Glossary P54x/EN SG/B94

MiCOM P543, P544, P545 & P546 (SG) 14-7

Logic timers

Logic
Explanation Time chart
symbols

INPUT
t
t OUTPUT
Delay on pick-up timer, t
0 INPUT
t
OUTPUT

INPUT

OUTPUT
0 t
Delay on drop-off timer, t INPUT
t
OUTPUT
t

INPUT
t1 t2
t1 OUTPUT
Delay on pick-up/drop-off timer
t2 INPUT
t1 t2
OUTPUT

INPUT
t
OUTPUT
Pulse timer
t
INPUT
t
OUTPUT

INPUT
Pulse pick-up falling edge t
t OUTPUT

INPUT
Pulse pick-up raising edge t SG
t OUTPUT

INPUT
Latching Latch
OUTPUT
P54x/EN SG/B94 Symbols and Glossary

(SG) 14-8 MiCOM P543, P544, P545 & P546

Logic
Explanation Time chart
symbols

INPUT

Dwell t
OUTPUT
Dwell timer
Timer
INPUT
t
OUTPUT

Straight (non latching): INPUT


Straight
Hold value until input reset signal OUTPUT

SG

You might also like