Scribd Logo
Upload

Welcome to Scribd!

  • 33 views

    EEE 128 Lab 3.2

    Uploaded by

    Allen Lois Lanuza
    EEE 128 Lab Manual

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    EEE 128 Lab 3.2

    Uploaded by

    Allen Lois Lanuza
    33 views2 pages
    EEE 128 Lab Manual

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    EEE 128 Lab Manual

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    33 views2 pages

    EEE 128 Lab 3.2

    Uploaded by

    Allen Lois Lanuza
    EEE 128 Lab Manual

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    EEE

    128 Lab 3.2: Layout




    Topics/Objectives:

    At the end of the session, the students must be able to
    • Assign footprints to components in a schematic
    • Create a PCB file for a schematic
    • Layout the tracks of the PCB



    Instructions
    1. Modify the schematic that you made from Lab 2.2 to the one shown in the attached
    schematic.
    2. Run the annotate tool to verify that there are no annotation errors.
    3. Enter the footprints of the components. As a starting point, use the footprints shown
    below. You may modify the footprints of the resistors and capacitors, but do not
    modify the other footprints.
    4. Open the layout editor by using tools->update pcb from schematic.
    5. Setup the layers. 2 layers, parts on front only.
    6. Setup the design rules. Set the track width to 0.5 mm.
    7. Draw a 150mm x 150mm square for the board outline on the Edge.Cuts layer. Your
    layout must be placed inside this board outline.
    8. Use the techniques that you have learned from the last lab activity to layout the board.
    9. You will need to add heatsinks for the voltage regulators and FET. Add the heatsink
    footprints by going to Place->Footprint and search for
    Heatsink:Heatsink_Fischer_SK104-STC-STIC_35x13mm_2xDrill2.5mm. Place the
    Voltage regulators and FET as shown in the figure below



    10. Run the DRC and resolve any errors.
    11. Generate the Gerber files.

    You might also like