Scribd
Upload
26 views

University of Petroleum and Energy Studies Assignment - I: L L Z L L in S Z Zmax

This document contains an assignment for a basic electrical and electronics engineering course. It includes 8 questions related to circuit analysis, rectifiers, diode characteristics, and voltage regulation. Students are asked to determine component values and voltages in circuits, draw circuit diagrams, explain diode specifications, and design a Zener voltage regulator. The questions cover fundamental concepts in circuits, diodes, and power electronics.

Uploaded by

Nikhil Gupta
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
26 views

University of Petroleum and Energy Studies Assignment - I: L L Z L L in S Z Zmax

This document contains an assignment for a basic electrical and electronics engineering course. It includes 8 questions related to circuit analysis, rectifiers, diode characteristics, and voltage regulation. Students are asked to determine component values and voltages in circuits, draw circuit diagrams, explain diode specifications, and design a Zener voltage regulator. The questions cover fundamental concepts in circuits, diodes, and power electronics.

Uploaded by

Nikhil Gupta
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

UNIVERSITY OF PETROLEUM AND ENERGY STUDIES

Assignment -I
Subject: Basic Electrical and Electronics Code: GNEG-143

Note: Attempt all the questions


1. For the circuit shown below Fig. (1), determine the values of VL, IL, IZ with RL = 200Ω
and RL = 50Ω. Comment on the operation of the circuit, where Vin = 20 V, RS = 220Ω,
VZ = 10 V, PZmax = 400 mW.

Fig. (1)
2. Draw the circuit diagram of bridge-type full wave rectifier and explain its operation with
neat input and output waveforms.
3. What do you understand by d. c. and a. c. resistance of a crystal diode? How will you
determine them from V-I characteristics of a crystal diode.
4. Determine the current I in the Fig. (2) . Assume Si diodes and forward resistance of
diodes to be zero.

Fig. (2)
5. Determine the currents I1, I2, I3. Use simplified model shown in Fig 3 as,
Fig. (3)

6. Explain the following terms relating to PN junction as,

(a) Knee Voltage


(b) Break down voltage
(c) Forward Current
(d) Reverse Current
(e) Maximum Forward Current
(f) PIV
(g) Maximum Power rating
(h) Static and dynamic forward resistances
(i) Reverse Resistances.

7. For the circuit shown in the Fig. (3).determine the output voltage when

(a) V1 =V2 = 0V (b) V1= 0V, V2= 5V (c) V1=5V, V2=0V (d) V1=V2= 5V
1

V1 Vo
Si
2

V2 3.3 k
Si

Fig. (3)
8. Design a Zener voltage regulator that will maintain an output voltage of 20 Volts across a
2 KΩ load when the input voltage range is 30-50 volts. Minimum Zener current (IZ) is 5 mA.
Calculate the maximum power rating of the Zener diode.

You might also like