0% found this document useful (0 votes)
228 views5 pages

A30 FM/DAB Monitoring Decoder

The A30 FM/DAB Monitoring Decoder is a professional receiver for monitoring FM and DAB signals. It has dual FM tuners, a DAB+ tuner, and can receive signals from 3 RF antennas. It provides measurement and monitoring of FM and RDS parameters, as well as optional DAB monitoring. It also features audio monitoring and measurement, backup and rebroadcast functions, IP streaming, and control via a web interface.

Uploaded by

fahmi1987
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
228 views5 pages

A30 FM/DAB Monitoring Decoder

The A30 FM/DAB Monitoring Decoder is a professional receiver for monitoring FM and DAB signals. It has dual FM tuners, a DAB+ tuner, and can receive signals from 3 RF antennas. It provides measurement and monitoring of FM and RDS parameters, as well as optional DAB monitoring. It also features audio monitoring and measurement, backup and rebroadcast functions, IP streaming, and control via a web interface.

Uploaded by

fahmi1987
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

A30 FM/DAB Monitoring Decoder

Professional, flexible FM/DAB Monitoring and


Measurement Receiver
Backup- and Rebroadcast-Receiver

Energy efficient,
no moving parts, no fan

RF capabilities
• Dual FM tuner, DAB+ tuner, 3 RF antenna inputs
• Large-signal characteristic: Up to 120dBµV RF input
• Preset for 30 FM stations (optional: 30 DAB+ stations/services)
FM monitoring and measurement
• Measurement / display of FM & RDS signal parameters
RF level, pilot, PI, PS, TP, TA, PTY, RT, BER, ODA AIDs, SNR, freq-offset,
MPath, MPX power, MPX deviation, pilot deviation, RDS deviation
Optional: graphical presentation of MPX power, MPX deviation distribution, MPX
deviation peak (see page 3 of datasheet)
• Demodulation and control of different FM programs
• Decoding of RDS parameters including TMC and RT+ messages (RDS Lab)
• Optional: scanmode for monitoring of up to 30 stations
• Optional: RDS Logger for continuous recording of all RDS group data
• Optional: Internal memory (up to 32 Gigabyte) for logging TMC, RT, RT+, TA,
MPX power, MPX deviation ; accessible via FTP
Optional: DAB/DAB+ Demodulation/Monitoring
• Ensemble: Label, Short Label, Ensemble ID, Date, Time, Workload,
RF Level, SNR, CNR, FIC Quality
• Station/Service: ID, Type, CA, Protection, Bitrate, Samplerate, Audio Mode,
DL, Title, Artist, Programm, Cat. Slideshow (50 slides)
Audio monitoring and measurement
• Display of audio level L and R (TRMS) for FM / DAB tuner, MPX Input and
audio input
Optional: external MPX input
• All MPX measurements and display for external MPX input possible
Audio/MPX output
• 2x output of audio AES/EBU, analog (switchable), 2x MPX output
High sophisticated alarm concept
• Alarm reporting via e-mail, SNMP, Web interface, activation of relay
contacts, Log and warning LEDs

www.2wcom.com • [email protected] • Am Sophienhof 8 • 24941 Flensburg • Germany • Fon (+49) 461 - 66 28 30 - 0 • Fax (+49) 461 - 66 28 30 - 11
A30 FM/DAB Monitoring Decoder

Backup and rebroadcast functions


• Professional rebroadcasting
• Passive loopthrough for audio and MPX with switch over matrix to FM signal
triggered by SNMP or GPIO input:
-- Insertion of a backup program (breakdown of main input, power failure)
• RDS databridge (UECP RDS data output via UDP/IP)
IP streaming
• 1x MP3 live streaming via TCP/IP, selectable (FM, DAB, MPX, Audio input)
optional: 2x MP3 live streaming,
Control
• Redesigned web interface for easy setup and simply control via standard web
browser
Compatibility
• Downward compatible to the A20s interfaces and instruction set
• Compatible to premium RDS decoding software RDS Lab

www.2wcom.com • [email protected] • Am Sophienhof 8 • 24941 Flensburg • Germany • Fon (+49) 461 - 66 28 30 - 0 • Fax (+49) 461 - 66 28 30 - 11
A30 enhanced webinterface
Measurement and graphical presentation
of MPX values (optional)

www.2wcom.com • [email protected] • Am Sophienhof 8 • 24941 Flensburg • Germany • Fon (+49) 461 - 66 28 30 - 0 • Fax (+49) 461 - 66 28 30 - 11
A30 DAB+
Monitoring and features (optional)

www.2wcom.com • [email protected] • Am Sophienhof 8 • 24941 Flensburg • Germany • Fon (+49) 461 - 66 28 30 - 0 • Fax (+49) 461 - 66 28 30 - 11
A30 FM/DAB Monitoring Decoder – Technical Details
according to CENELEC EN 60950,
EMV EN55022 and EN55024

Inputs Signal/Noise ratio


(75 kHz deviation)
Typ. 70 dB stereo

Harmonic distortion Typ. < 0.1%


RF-FM 2 unbalanced, BNC
internal switch matrix Stereo separation >40 dB
Impedance
Frequency Range
50 Ω
87.5...108.0 MHz
Digital Audio 2x AES/EBU balanced XLR
76.0...90.0 MHz (Japan) Headphone
50/100 kHz steps Connector 6.35 mm
RF sensitivity 35 dBμV
(S/N 40 dB, stereo)
Max. RF input 120 dBµV Front panel
RF-DAB 1 unbalanced, BNC (optional) LCDisplay
Jog wheel
Graphical, 264x64 pixel
Impulse, ENTER button
Impedance 50 Ω
Frequency Range 168-240 MHz (DAB Band III) 4 Duo LEDs Power, Input, Output, Warning
RF sensitivity 10 dBµV
Max. RF input 100 dBμV Alarm functions
MPX MPX loopthrough
optional: MPX measurements Controlling data FM RF level, MPX power, MPX peak deviation,
Connector BNC unbalanced, 1x rear no pilot, no RDS sync, TA, no TA, PI,
Impedance >10 kΩ PS, block error rate, pilot deviation, RDS
deviation, audio level L, audio level R
Inputs (passive loop through) Controlling data DAB (optional) Ensemble: RF Level, FIC Quality
Station (Service): audio level L, audio level
MPX connector BNC
AES/EBU / Audio L connector XLR R, Slideshow image update, Slideshow
Audio R connector XLR image loadtime
Control content (RDS group) received within x sec. / change
Alarm types Potential free relays, E-mail, SNMP, Log,
Measurement warning LED

FM Scanmode (optional)
RF level 20...120 dBµV
SNR Typ. 65 dB Max. stations 30
Frequency offset +/- 10 kHz Setup switch over time, RF input 1/2
MPATH 0...100% Control functions On all alarm functions
MPX power (graph: optional) -50...+20 dBr
MPX deviation (graph: optional) 120 kHz
MPX distribution cum. graph
(optional)
0...120 kHz Interfaces
Pilot deviation 0...+10 kHz Remote control input 7 inputs
Stereo blend 0...100% Connector 15 pole sub-D female
RDS 7 floating relays (6x SPST, 1x SPDT)
RDS deviation Measurement of RDS deviation Remote control output (for DC: max. 30 V, 0.5 A)
(error <3 %) Connector 15 pole sub-D male
RDS decoding Via web interface:
PI, PS, RT, TA, TP, ODA AIDs, PTY, CT,
TCP/IP data interface input/output setup functions
Connector RJ45
Additionally via RDS lab SW: Type full duplex 10/100 BASE-T
Group sequence, group statistics, content of Data format HTTP, SNMP, SNTP, optional: FTP
all group types, TMC , RT+
Optional: TMC Pro, EWR
RDS Block Error Rate 0...100% MP3-Encoder
Audio Type MPEG 1/2 Layer 3 encoder
Audio level Separate measuring of audio level L/R Transmission of encoded MP3 data Adjustable MPEG Encoder quality in 3 steps
(RMS) for tuner and input by TCP/IP Adjustable sample rates for latest Live-
DAB (optional) optional: 2x MP3 stream stream-Technology
Reception of Audio-Live-stream by shout-
RF Level 0…100 dBµV cast compatible media player like WinAmp
FIC Quality 0…100% or VLC or via web-browser
Audio Separate measuring of audio level Internal input from FM/DAB tuner module
L/R (RMS) optional: MPX in, Audio in
PAD DLS, Cat. Slideshow
Ensemble decoding Ensembl ID, Label, Short Label, Workload
(CU Usage), Service Count, Sub-Channel
Count, Date, Time
General data
Service / Subchannel decoding Service ID, Label, Short Label, CAId, Power consumption 40 VA
Sub-Channel ID, CU Start, CU Size, CA, Case dimensions 19“, 1 HU, 310/424/484 mm
Protection, Bitrate, Sample rate, Type Weight 5 kg
Housing steel plate (aluminum-zinc coated)
Operating temp. range 0...+45°C
Outputs Storage temp. range
Power supply
-40...+70°C
Internal, 90...260 V, 47...63 Hz
2x unbalanced BNC
Multiplex (On request: 1 balanced XLR)
Impedance <20 Ω
Level Max. 15 dBu
Frequency response 20 Hz...95 kHz ±0.1 dB
Signal/Noise ratio Typ. 70 dB stereo
(75 kHz deviation)
Harmonic distortion Typ. 0.05%
Stereo separation >48 dB

Analog Audio 2x L/R balanced XLR


Impedance <20 Ω
Level max. 15 dBu Version 06.09.2018
Frequency response 20 Hz...15 kHz ±0.1 dB These data are subject to
Deemphasis 50 μs (optional 75 μs) modifications and amendments.
Errors excepted

www.2wcom.com • [email protected] • Am Sophienhof 8 • 24941 Flensburg • Germany • Fon (+49) 461 - 66 28 30 - 0 • Fax (+49) 461 - 66 28 30 - 11

You might also like