Fosroc Trafficguard UR155: New Improved

ed
New Improv
Fosroc Trafficguard UR155 constructive solutions
Hard wearing, skid resistant, traffic deck system
Uses Typical Properties
Trafficguard UR155 is a polyurethane based traffic deck

Top coat
system designed to provide an added level of protection to,
new and existing, trafficked areas such as: Elongation
(ASTM D412) : > 200%
Car park decks
Tensile Strength
Car park ramps (ASTM D412) : 9 N/mm2
Tear Resistance
Service centres, garages
(ASTM D624) : 25 N/mm
Workshops Shore A Hardness
(ASTM D2240) : > 90
Advantages Overcoating time at 35°C : 16 hours
Crack Bridging ability
Flexible
(ASTMC1305) : Pass
Suitable for all zones in a car park
Chemical Resistance
Seamless and watertight
Trafficguard UR155 is resistant to a range of chemicals
Reliable and safe
including:
- Petrol, Engine Oil, Jet fuel, Brake fluid, Mineral spirit
Description - Diesel, Medium concentration acids
Trafficguard UR155 is a multi-layer flooring system - Detergents etc.

comprising a primer and flexible topcoat. All components
The above chemicals may cause staining. For full details
are applied in the liquid phase and react chemically to form a
contact your local Fosroc office.
tough, flexible, waterproof protective surface.
Trafficguard UR155 is available in a range of standard Instructions for use

colours. Contact your local Fosroc office for full details.
Surface Preparation
New concrete surfaces should have reached 80% of their

intended physical properties - generally only achieved after a
minimum curing period of 28 days. Existing concrete surfaces
must be prepared to provide a clean, sound substrate.
Surfaces should be clean and dry with open capillary, free

from laitance, oil and grease, curing compounds or other
surface contaminants which may prevent full and proper
adhesion of the primer. All blowholes, and other surface
undulations should be repaired using an appropriate Fosroc
product.
Trafficguard UR155
Fosroc Trafficguard UR155
Application Estimating
Primer Supply
Trafficguard Primer : 9 litre packs
Apply Trafficguard Primer to the prepared surface at an
Topcoat : 18 litre packs
application rate in the range of 0.2 to 0.3 ltr/m2. Quantity will
Antislip Grains No. 2 : 25 kg bags
depend on surface texture and porosity. General
TLMP ** : 18 litre packs
recommendation which will vary according to the project is a
coverage rate of 0.2 ltr/m2 for parking and thoroughfare; 0.3 ltr/ Coverage
m2 for ramps. Trafficguard Primer : 0.2 - 0.3 ltr/m²
Whilst Trafficguard Primer is still wet, blind with Anti Slip Grain Antislip Grain No. 2 : 0.4 - 0.8 kg/m²
No. 2 at an estimated rate of between 0.4 - 0.8 kg/m2, leave to dry Topcoat : 0.2 - 0.5 ltr/m²/coat
for 16 hours @ 35ºC. Prior to the removal of excess antislip TLMP : 5 m²/ltr
grain ensure that the grains are firmly embedded in the primer. (per coat - 2-3 coats recommended)
General recommendation which will vary according to the Note: The above coverage rates are given for guidance only
project. A minimum coverage rate of 0.2 ltr/m2 for parking and as actual quantities used will vary depending upon the
thoroughfare; 0.45 ltr/m2 for ramps. nature of substrate and conditions on site. It is strongly
Topcoat advised that trials are conducted to establish coverage
rates.
Apply Trafficguard Topcoat to the primed surface at an
application rate of 0.4 to 0.5 ltr/m² per coat. For best results the Technical Support
Trafficguard Topcoat should be applied with a short haired
lambswool roller. Fosroc offers a comprehensive technical support service to
specifiers, end users and contractors. It is also able to offer
Prior to trafficing allow the following cure periods: on-site technical assistance, an AutoCAD facility and dedicated
Foot traffic : 24 hrs @ 25°C or 18 hrs @ 35°C specification assistance in locations all over the world.
Vehicle traffic : 5 days @ 25°C or 72 hrs at 35°C
Storage
Traffic marking lines may be applied using Trafficguard Line
Marking Paint (TLMP) after five days from time of application. Shelf life
Cleaning When stored in warehouse conditions at less than 25°C,

Trafficguard UR155 will have a shelf life of 12 months. Avoid
Tools and equipment should be cleaned immediately after
storage of material under direct sunlight.
use with Fosroc Solvent 102*.
Trafficguard UR155 - Page 2 of 4

Limitations Precautions
- Trafficguard UR155 should not be applied on to surfaces Health and safety

which are known to or likely to suffer from rising damp or
Trafficguard Primer and Fosroc Solvent 102 should not come
have a relative humidity greater than 80% as measured in
in contact with skin or eyes, nor should they be swallowed.
accordance with BS8203 Appendix A or by Hammond
Avoid inhalation of vapours and ensure adequate ventilation.
concrete/mortar moisture tester type COCO.
Some people are sensitive to resins, hardeners and solvents.
- In conditions of high relative humidity i.e. 85-90%, good
Wear suitable protective clothing, gloves and eye/face
ventilation conditions are essential. Substrate temperature
protection. Barrier creams such as Kerodex Antisolvent or
should be atleast 3°C above dew point.
Rozalex Antipaint provide additional skin protection.
- Do not proceed with application if precipitation is imminent,
Should accidental skin contact occur, remove immediately with
or temperatures are expected to drop below 7°C within 24
a resin removing cream such as Kerocleanse Standard Grade
hours of application.
Skin Cleanser or Rozaklens Industrial Skin Cleanser, followed
- If a glossy asthetic finish is required which is easily by washing with soap and water - do not use solvent.
cleanable recommend Trafficguard UR150, Trafficguard
The use of goggles is recommended, in case of accidental
UR or Trafficguard UREP.
eye contamination, rinse immediately with plenty of water and
- May discolour when exposed to direct sunlight over time. seek medical advice.
- Not recommended in Exposed conditions. If swallowed seek medical attention immediately - do not
induce vomiting.
High temperature working
Fire
It is suggested that, for temperatures above 35°C, the following
guidelines are adopted as good working practice: Fosroc Solvent 102 and Trafficguard Top coat are flammable.
Do not use near a naked flame.
(i) Store material in a cool (preferably temperature controlled)
environment, avoiding exposure to direct sunlight. Flash points
Fosroc Solvent 102 : 33°C
(ii) Keep equipment cool, arranging shade protection if
Trafficguard Topcoat : 33°C
necessary. It is especially important to keep cool those
surfaces of the equipment which will come in direct contact
with the material itself.
(iii) Try to eliminate application during the hottest times of the

day.
(iv) Make sufficient material, plant and labour available to

ensure that the application is a continuous process.
Trafficguard UR155 - Page 3 of 4

Additional Information
Fosroc manufactures a wide range of complementary

products which include :
waterproofing membranes & waterstops
joint sealants & filler boards
cementitious & epoxy grouts
specialised flooring materials
Fosroc additionally offers a comprehensive package of

products specifically designed for the repair and
refurbishment of damaged concrete. Fosroc’s ‘Systematic
Approach’ to concrete repair features the following :
hand-placed repair mortars
spray grade repair mortars
fluid micro-concretes
chemically resistant epoxy mortars
anti-carbonation/anti-chloride protective coatings
chemical and abrasion resistant coatings
For further information on any of the above, please consult

your local Fosroc office - as below.
* Denotes the trademark of Fosroc International Limited
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions for
the Supply of Goods and Service. All Fosroc datasheets are updated on a regular basis. It is the user’s responsibility to
obtain the latest version.
Head Office
telephone: (+9714) 2039699 fax: (+9714) 2859649 email: [email protected]
Al Gurg Fosroc LLC
Regional offices
Post Box 657, Dubai Abu Dhabi, Al Gurg Fosroc telephone: 673 1779 fax: 673 1449 email: [email protected]
United Arab Emirates Bahrain, YBA Kanoo telephone: 17738200 fax: 17732828 email: [email protected]
Kuwait, Boodai telephone: 4817618 fax: 4832124 email: [email protected]
www.fosroc.com
Oman, Al Amana telephone: 24815080 fax: 24817554 email: [email protected]
Qatar, Tadmur telephone: 4432365 fax: 4419517 email: [email protected]
UAE/0665/10/B

Fosroc Trafficguard UR155: New Improved

Uploaded by

Copyright:

Available Formats

Fosroc Trafficguard UR155: New Improved

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Fosroc Trafficguard UR155: New Improved

Uploaded by

Copyright:

Available Formats

ed

Hard wearing, skid resistant, traffic deck system

Uses Typical Properties

Trafficguard UR155 is a polyurethane based traffic deck

- Petrol, Engine Oil, Jet fuel, Brake fluid, Mineral spirit

Description - Diesel, Medium concentration acids

Trafficguard UR155 is a multi-layer flooring system - Detergents etc.

Trafficguard UR155 is available in a range of standard Instructions for use

New concrete surfaces should have reached 80% of their

Surfaces should be clean and dry with open capillary, free

Cleaning When stored in warehouse conditions at less than 25°C,

Trafficguard UR155 - Page 2 of 4

- Trafficguard UR155 should not be applied on to surfaces Health and safety

(iii) Try to eliminate application during the hottest times of the

(iv) Make sufficient material, plant and labour available to

Trafficguard UR155 - Page 3 of 4

Fosroc manufactures a wide range of complementary

 waterproofing membranes & waterstops

 joint sealants & filler boards

 cementitious & epoxy grouts

 specialised flooring materials

Fosroc additionally offers a comprehensive package of

 hand-placed repair mortars

 spray grade repair mortars

 chemically resistant epoxy mortars

 anti-carbonation/anti-chloride protective coatings

 chemical and abrasion resistant coatings

For further information on any of the above, please consult

* Denotes the trademark of Fosroc International Limited

You might also like

waterproofing membranes & waterstops

joint sealants & filler boards

cementitious & epoxy grouts

specialised flooring materials

hand-placed repair mortars

spray grade repair mortars

chemically resistant epoxy mortars

anti-carbonation/anti-chloride protective coatings

chemical and abrasion resistant coatings