Scribd
Upload
59 views2 pages

Update For The Assembling Drawing by Changing From RS232 To USB

The document provides instructions for updating various assembly drawings to change connections from RS232 to USB. Specific changes include replacing assembly positions for some parts and fixing other parts in new positions.

Uploaded by

Richard Alberth Poma Gomez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views2 pages

Update For The Assembling Drawing by Changing From RS232 To USB

The document provides instructions for updating various assembly drawings to change connections from RS232 to USB. Specific changes include replacing assembly positions for some parts and fixing other parts in new positions.

Uploaded by

Richard Alberth Poma Gomez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Update for the Assembling Drawing by changing from

RS232 to USB

Because of difference type of connection between RS232 and USB, some of assembling drawing
have been changed.

<USB cable and USB CPU>


--------------------------------------------------------------------------------------
Robokit 2. ServoBot p48 assembling No 8

Replace assembling position A11, A5, and K5 to A10,


A4, and K4 in that order.

------------------------------------------------------------------
Robokit 3. DiceBot p32 Assembling No 2 Robokit 3. DiceBot p34 Assembling No 8

bolt x 1
30mm support x 1

wheel guide x 1

Replace assembling position I12 to I13 Change the 20mm support to 30mm support
Robokit 4. SupertankBot p25

receiver x 1
CPU x 1
battery case x 1
4hole frame x 2
motor frame x 2
caterpillar(45) x 2

Fix support to the remote control receiver with position D1 and D15.

------------------------------------------------------------------------------

Robokit 5. GumdoBot p97

Fix the motor drive board on


CPU positioned K5 and K7.

CPU x 1
motor driver board x 1
servo motor x 1
5hole frame x 3
motor frame x 6
15mm support x 2

You might also like