Scribd
Upload
129 views2 pages

Manual Feedback Assembly (PFW) : Valco Instruments Co. Inc

Nalco tn106

Uploaded by

rasool Fakhraie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
129 views2 pages

Manual Feedback Assembly (PFW) : Valco Instruments Co. Inc

Nalco tn106

Uploaded by

rasool Fakhraie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Technical Note 106

Valco Instruments Co. Inc.

Manual Feedback Assembly (PFW)


For Valco W-type and UW-type Valves
The PFW, comprising a knob with a socket head set screw and a bearing plate with a contact and
signal cable, provides position feedback for two position manually-actuated valves in the form of a
permanent contact closure for TTL logic signals at Position B.

Installation on an Existing Manual Valve


Refer to the drawing below.
1. Loosen the set screw within the knob and slip the knob off the end of the manual drive shaft.
2. Remove the two socket head cap screws holding the bearing plate to the rest of the valve assembly,
gripping the assembly so that the parts will stay together when the screws are removed.
3. Slide the bearing plate off of the manual drive shaft and orient the valve and shaft housing to align
with the mounting bracket as indicated in the table on the next page of this document.
4. Slide the bearing plate supplied as part of the PFW over the drive shaft, aligning its holes with the
holes in the shaft housing and valve. Secure it with the two socket head cap screws.
5. Slide the knob onto the drive shaft so that the set screw is aligned with the flat on the shaft, and
tighten the set screw.

Contact Signal Specifications


Maximum voltage: 48 VAC/VDC BEARING SHAFT MANUAL
Maximum amperage: 0.1 A PLATE HOUSING DRIVE
SHAFT
Maximum power: 5W

SOCKET HEAD
CAP SCREWS

VALVE
INDICATOR

MOUNTING
BRACKET
KNOB

SOCKET HEAD SIGNAL


SET SCREW CABLE

1
Orientation of
Valve and Orientation of Orientation of Orientation of
valve ports and
PFW type knob in Position B bearing plate shaft housing
mounting holes

A B Indicator
on knob 1
C10W outer 2 10
C10UW surface

PFW36
10 ports
36° throw

B
A 1 8
C8W
C8UW
PFW45
8 ports
45° throw

A B
1
C6W
2 6
C6UW
PFW60
6 ports
60° throw

A B 1
C4W
C4UW
2 4
PFW45
4 ports
90° throw 3

A
W S
CI4W
CI4UW
P
B
PFW90 C
4 ports
90° throw

North America, South America, and Australia/Oceania contact: Europe, Asia, and Africa contact: TN-106 Rev 7/13
Valco Instruments Co. Inc. VICI AG International
® ®

P.O. Box 55603 Parkstrasse 2


Houston, TX 77255 CH-6214 Schenkon
Sales: (800) 367-8424 Switzerland
Tech: (713) 688-9345 Phone: +41 41 925 6200
Fax: (713) 688-8106 [email protected] Fax: +41 41 925 6201 [email protected]
Cheminert® and VICI® are registered trademarks of Valco Instruments Co. Inc. and VICI AG

You might also like