The CM Series 5 colaescer cartridges are available
in two cartridge mounting styles; self-centering rod mount and screw base. The rod mount style has treated metal end caps, while the screw base ends are injection molded, glass-filled nylon. This screw base material offers superior strength and ease of maintenance- uniform threads, no shrinkage, no galling and no gasket recover.
A permanently affixed Buna gasket seals against the
V-type knife edge mounting adaptor to provide a positive seal. It will not separate from the cartridge during installation or change out.
STANDARD DESIGN FEATURES
•• Tested and qualified to the Fifth Edition of EI 1581 for all category “M” FOR MAXIMUM WATER COALESCING •• Multi-layered media for increased solids EFFICIENCY AND SOLIDS HOLDING holding capacity CAPACITY •• Ultra-fine solids removal Facet CM Series coalescer cartridges offer the fin- •• Maximum water coalescence est performance available. This line of high flow •• Balanced cartridge flow characteristics coalescer cartridges removes ultra-fine solids and •• Recommended maximum operating enhances separation of water from jet fuel. temperature: 240oF (115oC) •• Withstands excess of 75 psi differential The Facet coalescer separator housings equipped pressure with CM Series coalescer and companion separa- •• pH range from 5 to 9 tor cartridges have been tested and fully qualified •• Choice of self-centering rod or screw base to EI 1581, Fifth Edition, for category “M”, in both coalescer cartridge mounting styles vertical and horizontal orientations.
Built for balanced fluid flow-thru and structural MATERIALS
strength, each CM Series coalescer cartridge is a •• All metal components are treated against single piece construction of various combined corrosion media, precisely arranged in many layers and •• Screw base ends are injection molded, pleats, wrapped around a coated, perforated met- glass-filled nylon with locked-in gaskets al center tube- all encased in an outer sock mate- •• Buna-N gaskets-other materials are available rial. All are 6” OD (152mm) by 3.5” ID (89mm) and upon request available in standard interchangeable nominal •• Buna-N gaskets-other materials are available lengths in increments from 11.25” (290mm) to upon request 57.25” (1450mm).
Bearings And Bearing Metals: A Treatise Dealing with Various Types of Plain Bearings, the Compositions and Properties of Bearing Metals, Methods of Insuring Proper Lubrication, and Important Factors Governing the Design of Plain Bearings
