MBF 40 Series - EMEA APAC - Rev D PDF

gsm and wcdma
900 / 1800 / 2100
mbf-40 series
Single band, Dual band, Tri band
for EMEA and APAC
PRODUCT BENEFITS
High output power
Low noise figure leading to higher system sensitivity
Advanced and user-friendly remote control and supervision
Three Bands in one enclosure
Convection cooling
The Multi-Band Fibre optic fed the MTBF figures compared to if system can be used to distribute
system encapsulates solutions for active fans were to be used. The the signal throughout the area to
both indoor and outdoor environ- high output power results in a be covered.
ments for single or multi-operator need to deploy a fewer number
use. It offers seamless coverage of sites, which in turn lowers the Axell Wireless can provide a
in any indoor environment such capital expenditures for the roll- complete solution including design,
as tunnels, metros and larger out as a whole. site surveys and equipment
buildings. Signals are coupled off related to the POI (Point Of
from a nearby base station and These remote units can be Interface) such as combiners,
then distributed via fiber to one or installed up to 20 km from the filters, cross band couplers, etc.
several MBF-40 repeaters. base station site, offering a great The MBF-40 product family in-
flexibility when providing RF cludes version for single band,
This solution offers very high coverage in areas where off air dual band as well as tri band cov-
output power, yet uses convec- transmission is not a preferable erage, available in the following
tion cooling, which increases solution. A distributed antenna combinations:
single band dual Band Tri band

E-GSM/WCDMA 900, GSM 1800, WCDMA 2100 E-GSM & WCDMA 2100 E-GSM & GSM 1800 & WCDMA 2100
The technical performances for each band are found on the back of this data sheet. Regardless of the
MBF-40 repeater version (single, dual or tri band) these high performances remain constant.
Automatic optical gain setting

The gain is adjusted in the downlink chain by measuring the level of the pilot carrier sent from the Optical
Master Unit (OMU). The level of the received pilot carrier is continuously monitored.
SPECIFICATIONS
Frequency Range UPLINK DOWNLINK
E-GSM 880 - 915 MHz 925 - 960 MHz
GSM 1800 1710 - 1785 MHz 1805 - 1880 MHz
WCDMA 2100 1920 - 1980 MHz 2110 - 2170 MHz
Bandwidth/power E-GSM GSM1800 WCDMA2100
Operational bandwidth 35 MHz 75 MHz 60 MHz
Composite output power (DL) +37 dBm* +37 dBm* +39 dBm
(for PAR of 8.5 dB)
* in repeaters that share a common downlink fibre for 900MHz and 1800MHz a minimum of 4 carriers in each band is required for
the full composite output power to be attainable maintaining full ETSI compliance.
Noise figure 3 dB typical (maximum gain)
Propagation delay < 2 μs
Modulation Accuracy at nominal output power
GSM/GMSK < 2.5˚ RMS and < 10˚ peak
EDGE/8-PSK < 3 % EVM RMS
WCDMA/EVM < 12.5 % RMS (composite according to ETSI TS 25.106 with TM 1 / 64 DPCH)
PkCDE < - 33 dB (according to ETSI TS 25.106 with TM 1/64DPCH and spreading factor 256)
Gain UL/ DL Adjustable, in 1 dB steps.
System impedance 50 Ω
Return loss at antenna connections >14 dB
Antenna connectors DIN 7/16
Electrical ratings 230 VAC 50Hz, 115 VAC 60 Hz, - 48 VDC
Power Consumption single Band Dual band Tri band
140W 220W 350W
Mechanical single Band Dual band Tri band
Dimensions 540 x 382 x 198 mm 540 x 382 x 198 mm 540 x 382 x 313 mm
Weight 20 kg 22 kg 33 kg
Enclosure Aluminium (IP 65)
Environmental
EMC See compliance below
Operating Temperature - 25 to + 55 ° C
Storage - 30 to + 70 ° C
Humidity ETSI EN 300 019-2-4 (see compliance below)
MTBF > 100 000 hrs
Complies in applicable parts, relevant on R&TTE Directive including
different markets, to: ETS EN 301 502 ( ETS EN 300 609-4 / GSM 11.26 )
ETSI TS 25.106,ETSI 25.143
ETSI EN 301 908-11
ETS EN 301 498-8,
EN 60 950, EN 50 385
About Axell Wireless

Axell Wireless is one of the top 3 global providers of wireless coverage solutions and the market leader in the provision of
solutions for the public safety market worldwide. Applications for Axell Wireless equipment include coverage solutions for all sorts
of environments including road and rail tunnels, metros, small and large buildings and transportation systems such as railways and
aeroplanes. With its headquarters in the UK, Axell Wireless has been operating for over 30 years and has a substantial international
presence operating out of 10 offices across 4 continents. A proven track record combined with a worldwide reputation for providing
innovative and high quality products have made Axell Wireless a truly global player in the wireless coverage industry.
www.axellwireless.com
MBF-40 series_EMEA & APAC_rev D • © Axell Wireless Ltd

MBF 40 Series - EMEA APAC - Rev D PDF

Uploaded by

Copyright:

Available Formats

MBF 40 Series - EMEA APAC - Rev D PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MBF 40 Series - EMEA APAC - Rev D PDF

Uploaded by

Copyright:

Available Formats

gsm and wcdma

900 / 1800 / 2100

single band dual Band Tri band

Automatic optical gain setting

About Axell Wireless

MBF-40 series_EMEA & APAC_rev D • © Axell Wireless Ltd

You might also like