Scribd
Upload
370 views2 pages

Press Fit Calculator V 2.1: Shaft

This document contains information used in a press fit calculator to determine the pressure and force required for a press fit between a shaft and hub. It lists properties like diameters, tolerances, and materials for the shaft and hub. The maximum interference is 0.015 mm, generating a maximum pressure of 33.6 MPa. The force required to engage or disengage the shaft and hub is 19,000N, calculated using the friction coefficient, contact area and width of the hub.

Uploaded by

nitin chauhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
370 views2 pages

Press Fit Calculator V 2.1: Shaft

This document contains information used in a press fit calculator to determine the pressure and force required for a press fit between a shaft and hub. It lists properties like diameters, tolerances, and materials for the shaft and hub. The maximum interference is 0.015 mm, generating a maximum pressure of 33.6 MPa. The force required to engage or disengage the shaft and hub is 19,000N, calculated using the friction coefficient, contact area and width of the hub.

Uploaded by

nitin chauhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 2

Press Fit Calculator v 2.

Shaft
Young's Modulus, Ei (Gpa) 210.0
Poisson's Ratio, νi 0.292
Shaft Internal Diameter, di (mm) 0.000
Shaft Nominal Diameter, d (mm) 60.000
Shaft Upper Tolerance (mm) 0.030
Shaft Lower Tolerance (mm) 0.011
Shaft Maximum Diameter (mm) 60.030
Shaft Minimum Diameter (mm) 60.011

Hub
Young's Modulus, Eo (Gpa) 210.0
Poisson's Ratio, νo 0.292
Hub Outer Diameter, do (mm) 100.00
Hole Nominal Diameter, d (mm) 60.000
Hole Upper Tolerance (mm) 0.019
Hole Lower Tolerance (mm) 0.000
Hole Maximum Diameter (mm) 60.019
Hole Minimum Diameter (mm) 60.000

Pressure Generated between Shaft and Hub


Maximum Radial Interference, δmax (mm) 0.0150

Max Pressure Generated, pmax (MPa) 33.6


Force Required to Engage/Disengage Shaft and Hub
Width of Hub, w (mm) 10.00
Friction Between Shaft and Hub, μ 0.30
Area of Contact, A (mm )
2
1,885
Force Required, F (N) 19,000
A MEADinfo Product

You might also like