Scribd
Upload
235 views6 pages

Step by Step Procedure To Connect Tesys T Through Somove Software

1. To connect a Tesys T drive to Somove software, use connection cable TCSMCNAM3M002P and install the latest version of Somove software. 2. Plug the connection cable into the USB port on the PC and identify the assigned COM port in Device Manager. 3. Configure the Modbus Serial driver settings and Somove software settings to match the provided screenshots. Then connect the RJ45 end of the cable to the Tesys T drive to establish communication.

Uploaded by

mejmak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
235 views6 pages

Step by Step Procedure To Connect Tesys T Through Somove Software

1. To connect a Tesys T drive to Somove software, use connection cable TCSMCNAM3M002P and install the latest version of Somove software. 2. Plug the connection cable into the USB port on the PC and identify the assigned COM port in Device Manager. 3. Configure the Modbus Serial driver settings and Somove software settings to match the provided screenshots. Then connect the RJ45 end of the cable to the Tesys T drive to establish communication.

Uploaded by

mejmak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Step by step procedure to connect Tesys T through Somove Software.

1. It is recommended to use the Somove software version 1.9.2 or 2.0 or latest available in
Schneider website.
2. You can use the connection cable TCSMCNAM3M002P for connecting the Altivar VFD or Tesys T
with Somove software
3. Connect the TCSMCNAM3M002P cable in USB port
4. Go to PC start ---> Control Panel ---> Device manager --->Port (COM). It should show
TXSCUSB485(COM3) as shown in screen shot below.

5. If COM 3 is assigned for other purpose, the cable also can be assigned to any of the COM port as
shown screen shot below.
6. Go to PC start ---> Control Panel ---> Driver manager --->Modbus Serial Driver --->
(1)Configuration. The setting should be as shown in screen shot below.

7. Open Somove software form start ---> Click on Edit Connection ---> Press Modbus Serial --->
Press Advanced Setting ----> check the settings are as shown in screen shot below.
8. The Scan mode should be Monopoint as shown in screen shot below.

9. Connect the cable RJ45 connector in to LTME/HMI port available in Tesys T. Power on the
control supply to Tesys T
10. Somove ---> Edit Connection ---> Scan Netowrk – You will find as like the screen shot below.
11. Select the Tesys T displayed and presses “Connect”. Now the Tesys T will get connected with
Somove to do the programming and monitoring.
We believe above information will help you to solve the connection problem.

You might also like