Shell Gas Compressor Oil S4 PV 190 (En) TDS
Shell Gas Compressor Oil S4 PV 190 (En) TDS
Shell Gas Compressor Oil S4 PV 190 (En) TDS
Shell Gas Compressor Oil S4 PV has been specially developed as a versatile cylinder lubricant for reciprocating
compressors handling a range of hydrocarbon and other gases. It is based on polyalkylene glycol base fluids and is
fully approved by leading gas compressor manufacturers.
and bearings operate in a gas atmosphere. common seal and packing materials, including butyl, nitrile,
forced feed lubrication of the plain bearings (crankcase in conjunction with mineral oils swell slightly in operation,
· Change-over Procedure
Special changeover procedures are required when moving from
mineral oil-based products to Shell Gas Compressor Oil S4 PV
and vice versa.
Pour Point 0
C ISO 3016 -30
These characteristics are typical of current production. Whilst future production will conform to Shell's specification, variations in
these characteristics may occur.
Health, Safety & Environment
Avoid contact with skin. Use impervious gloves with used oil. After skin contact, wash immediately with soap and water.
Guidance on Health and Safety is available on the appropriate Material Safety Data Sheet, which can be obtained from
http://www.epc.shell.com/
Additional Information
· Advice
Advice on applications not covered here may be obtained from your Shell representative.