Scribd
Upload
240 views2 pages

AD07.61-P-4000-45L Pedal Value Sensor, ME-SFI Fault Code Description Engine 112.912 /916 /946 /953

teste de erro

Uploaded by

Fabio Gilii
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
240 views2 pages

AD07.61-P-4000-45L Pedal Value Sensor, ME-SFI Fault Code Description Engine 112.912 /916 /946 /953

teste de erro

Uploaded by

Fabio Gilii
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

AD07.

61-P-4000-45L Page 1 of 2

AD07.61-P-4000-45L Pedal value sensor, ME-SFI fault Engine 112.912 /916 /946 /953
code description

1 Fault code P20CF Voltage difference between signal 1 and signal 2 (P0120)
( Display on generic scan tool) P20DC Interruption at signal path 1 (P0120)
P20DD Short circuit at signal path 1 (P0120)
P20DE Interruption at signal path 2 (P0120)
P20DF Short circuit at signal path 2 (P0120)
P20E3 Voltage supply to accelerator pedal sensor (P0120)
2 Fault storage After expiry of test duration and fault

Activation of the engine diagnosis Following two successive driving cycles with faults
indicator lamp (EURO3/4)
or CHECK ENGINE (MIL) malfunction
indicator lamp
3 Checking frequency Continuous
4 Checked signal or status Voltages at accelerator pedal sensor
5 Fault setting conditions
Voltage difference between signal 1 The signals may deviate from one another in the idle speed position no more than
and signal 2 8 %.
For comparison purposes, signal 2 is multiplied by 2.
Short circuit to positive
If signal 1 is larger than 4.9 V or signal 2 larger than 2.4 V, a short-circuit to
positive is present (12 V or 5 V) or the accelerator pedal sensor is faulty.
Short circuit to ground/open circuit
If signal 1 is smaller than 0.2 V or signal 2 smaller than 0.1 V, the cause is a short
to ground, an interruption or the accelerator pedal sensor is faulty.
Voltage supply
The voltage supply to the accelerator pedal sensor must lie between 4.75 to 5.25
V.
6 Check prerequisites Ignition ON
7 In the event of a fault, emergency mode is activated.

B37 Accelerator pedal sensor (with 2 Hall elements)


N3/10 ME-SFI control unit
SP1M Ground, Hall element for signal 1
SP1S Signal 1 (limited to 5 V)
SP2M Ground, Hall element for Signal 2
SP2S Signal 2 (limited to 2.5 V)
USP1 Voltage supply to accelerator pedal sensor 5 V

P30.20-2033-11

© 2006 Mercedes-Benz USA, LLC


AD07.61-P-4000-45L Page 2 of 2

© 2006 Mercedes-Benz USA, LLC

You might also like