Installation of Programming-Board Software
Installation of Programming-Board Software
Figure 1
Figure 2
Programming-Board Photo
Figure 4
2. When connect USB line to computer, it will pop out USB driver installation window, see figure 5
Figure 5
3. Select the USB Driver path, and click to next till finished, see figure 6
Figure 6
Software Photo
Function Introduction
Version types, Hardware Version is without password protection, MCU SFP, XFP, SFP+ and
This button is only available for XFP. If the Transceiver module is XFP, table01 is for the basic
This button display the waiting time after write password, only for the module is password
protected effective.
Demonstration
Please set value as 128 if read the last 128 bytes data of A0, or if need to read the user
information of A2, please set value as A2 and set as 128, then click Read button.
Click to inputting the basic information or modifying information directly. Then click for
final writing. Please set as A2 and as 128 if need to write A2 user information.
Reading XFP EEPROM Information
information and Table02 for user information. Click for data reading.