Mason Ary

Design of Masonry Structures Civil
Objective Questions - Set 01

Civil MCQ
Practice Test: Question Set - 01
1. Rich cement mortars are more liable to cracking as compared to lean mortars because rich mortars have
(A) High shrinkage
(B) Less strength
(C) Both (A) and (B)
(D) None of above

Correct Answer
2. In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as
(A) Sum of thickness of both leaves
(B) Two-third of the sum of thickness of both the leaves
(C) Actual thickness of the stronger leaf
(D) Larger of (B) and (C)

Correct Answer
3. Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.
Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.
Select your answer based on the codes given below. Codes:
(A) Both A and R is true and R is the correct explanation of A
(B) Both A and R is true but R is not a correct explanation of A
(C) A is true but R is false

(D) A is false but R is true
Correct Answer
4. For earthquake resistant masonry buildings, the vertical distance between openings one above the other in
a load bearing wall shall not be less than
(A) 50 cm
(B) 60 cm
(C) 75 cm
(D) 100 cm
Correct Answer
5. The mode of failure of a very short masonry member having h/t ratio of less than 4 is by
(A) Shear
(B) Vertical tensile splitting
(C) Buckling
(D) Any of the above

Correct Answer
6. Where a structural component or a system is providing lateral support to five or more walls or columns,
the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded
wall or column in the group
(A) 4 %
(B) 5 %
(C) 6 %
(D) 7 %
Correct Answer
7. Consider the following statements regarding bands to be provided for strengthening masonry work in
masonry buildings constructed in zone III, IV and V.
(i) Lintel band is provided at lintel level on partition walls,
(ii) Gable band is provided at top of gable masonry below the purlins,
(iii) The bands shall be to full width of the wall and not less than 7.5 cm in depth,
(iv) The bands shall be made of reinforced concrete only.
Of these statements, the correct statements are
(A) (i) and (ii)
(B) (i) and (iii)
(C) (ii) and (iv)
(D) (ii) and (iii)

Correct Answer
8. The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of
(A) 1.2
(B) 1.4
(C) 1.6
(D) 2.0
Correct Answer
9. The timber floor not spanning on the masonry wall but properly anchored to the wall gives
(A) Lateral restraint but not rotational restraint
(B) Rotational restraint but not lateral restraint
(C) Both lateral and rotational restraints
(D) Neither lateral nor rotational restraint

Correct Answer
10. A free standing brick wall 20 cm thick is subjected to a wind pressure of 75 kg/m². The maximum height
of wall from stability consideration is
(A) 0.64 m
(B) 0.96 m
(C) 1.28 m
(D) 1.5 m
Correct Answer
11. Consider the following statements: The use of relatively weak mortar
1. Will accommodate movements due to loads and, cracking if any, and will be distributed as
thin hair cracks which are less noticeable or harmful.
2. Will result in reduction of stresses due to differential expansion of masonry units.
Of these statements
(A) 1 alone is correct
(B) 2 alone is correct
(C) Both 1 and 2 are correct
(D) Neither 1 nor 2 is correct

Correct Answer
12. If ‘H’ is the height of wall between centers of supports, then the effective height of wall where concrete
floors have a bearing on wall irrespective of the direction of span will be
(A) 0.75 H
(B) 0.85 H
(C) 1.0 H
(D) 1.5 H
Correct Answer
13. For designing masonry components of a structure, seismic forces provision in the design calculation is not
necessary for buildings constructed in
(A) Zone I only
(B) Zone I and II
(C) Zone I, II and III
(D) Zone I, II, III and IV

Correct Answer
14. A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height
between RCC slabs at top and bottom. The slenderness ratio of the wall is
(A) 15
(B) 19
(C) 20
(D) 25
Correct Answer
15. Water retentivity for brick masonry should not be less than
(A) 50 %
(B) 60 %
(C) 70 %
(D) 80 %
Correct Answer
View All Answers

01. Answer: Option A 02. Answer: Option D 03. Answer: Option C 04. Answer: Option B 05. Answer: Option A
06. Answer: Option D 07. Answer: Option D 08. Answer: Option C 09. Answer: Option A 10. Answer: Option A
11. Answer: Option C 12. Answer: Option A 13. Answer: Option B 14. Answer: Option A 15. Answer: Option C
Show/hide

Mason Ary

Uploaded by

Copyright:

Available Formats

Mason Ary

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Mason Ary

Uploaded by

Copyright:

Available Formats

Design of Masonry Structures Civil

Objective Questions - Set 01

Practice Test: Question Set - 01

(A) High shrinkage

(B) Less strength

(C) Both (A) and (B)

(D) None of above

(A) Sum of thickness of both leaves

(B) Two-third of the sum of thickness of both the leaves

(C) Actual thickness of the stronger leaf

(D) Larger of (B) and (C)

(A) Both A and R is true and R is the correct explanation of A

(B) Both A and R is true but R is not a correct explanation of A

(C) A is true but R is false

(B) Vertical tensile splitting

(D) Any of the above

(A) (i) and (ii)

(B) (i) and (iii)

(C) (ii) and (iv)

(D) (ii) and (iii)

(A) Lateral restraint but not rotational restraint

(B) Rotational restraint but not lateral restraint

(C) Both lateral and rotational restraints

(D) Neither lateral nor rotational restraint

(A) 1 alone is correct

(B) 2 alone is correct

(C) Both 1 and 2 are correct

(D) Neither 1 nor 2 is correct

(A) Zone I only

(B) Zone I and II

(C) Zone I, II and III

(D) Zone I, II, III and IV

View All Answers

You might also like